Dimplex BF series manual Operation, Remote Control Initialization

OPERATION

REMOTE CONTROL

The remote control has a range of approximately 50ft. (15.25m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls).

	Remote Control Initialization
	This procedure is may be required if there is a loss of power
	to the remote control in the fireplace. (i.e. power failure,
	breaker tripped, main power switch is turned off) or if a new
	remote is used.
	1.	Ensure that power is supplied through main service
	panel.
	2.	Locate manual controls (FIGURE 2)
	3.	Activate main power switch.
	4.	Press — (on) button located on the Manual Selection
	Control for 3 seconds (FIGURE 3). All 3 indicators will
FIGURE 1	flash.
	Press the ON button on the transmitter (FIGURE 1). The
	indicators will flash rapidly and then turn off. This will
	synchronize the remote control transmitter and receiver.

A. Remote Control Usage

FIGURE 2

The remote control operates the fireplace levels sequentially. The level is increased every time the ON button on the transmitter is pressed. The fireplace can be turned off at any point by pressing the OFF button on the remote control transmitter.

Thermostat control

FIGURE 2 Main power switch

Level 1: The flame effect is turned on and the first red indicator light is activated.

Level 2: The flame effect remains on, and the PurifireTM is activated. The first and second red indicator lights are activated.

Level 3: The flame effect remains on, the heater is activated, and all three red indicator lights are activated.

4