Bostoniantm SS
Space Saver Gas Fireplace
Tested and listed by
FRAMING - TOP & REAR VENT | DIMENSIONS |
HINT : place the fireplace so the center line is at least 5" from both vertical framing members at the rear (this allows the vent to pass through the framing without modifications)
Minimum Fireplace Enclosure Height: 38” for Rear Vent
Route the electrical line to a position to the left rear of the fireplace.
Included Firestop (required)
Part #
Vent Clearances (8" dia. Vent): 1" to the sides, 1" below, and 4" above the vent to combustibles.
Center of
Rear Vent
Top Vent Configuration |
|
|
8" Diameter Vent |
|
|
|
| |
| ||
|
| |
|
| |
|
| |
|
| |
| Rear Vent Configuration | |
|
| |
|
| 8" Diameter Vent |
30"* |
|
|
|
| |
|
|
* Includes the required 1/2" clearance. |
The on/off switch/thermostat wire (if used) should be routed to a location near the right front of the fireplace.
CORNER INSTALLATION REAR VENT
Minimum 1" Clearance |
|
| Firestop |
| Minimum 1/2" Clearance | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
7" Approximate (varies due to vent
NOTE
Most installations use: 6" Section for 2x6 Walls 4" Section for 2x4 Walls
CORNER INSTALLATION TOP VENT
Minimum 1/2" Clearance
Improper installation of your gas appliance or failure to operate it in accordance to the guidelines detailed in the Owner’s Manual may negate your warranty and endanger your home and family. Installation information is available on our website at: www.lopifire.com. We recommend all Lopi appliances be installed and maintained on an annual basis by your local authorized Lopi dealer.
Your Lopi Authorized Dealer is Located At:
Visit our Website at: www.lopifire.com
© Copyright T. I. 2007 Printed in U.S.A.
Photos and illustrations are for descriptive purposes only. | We reserve the right to improve or change our products without prior notification. Consult the Owner’s Manual for complete installation requirements. | #98800148 |