Pella installation instructions Part Number 80JJ0103

Page 1

©2008 Pella Corporation

Part Number: 80JJ0103

INSTALLATION INSTRUCTION - INSTRUCCIONES DE INSTALACION FOR CLAD HINGED PATIO DOOR WITH ADJUSTABLE HINGES PARA LA PUERTA PARA PATIO REVESTIDA, CON BISAGRAS ADJUSTABLES

$PSOFS 'MBTIJOH 5BQF

'JO

$PSOFS

%PPS5PQ

/BJMJOH'JO

5PQ

'MBTIJOH 5BQF $PSOFS

4JEF'MBTIJOH

'MBTIJOH 5BQF 5BQF

0QUJPOBM /BJMJOH'JO

 

 

BUFS

 

 

3FTJTUJWF

 

 

#BSSJFS

 

 

4IFBUIJOH

 

 

'SBNJOH

4JEF

 

 

'MBTIJOH

 

4JMM'MBTIJOH5BQF

5BQF

4JMM4VQQPSU

4JMM'MBTIJOH5BQF

%PPS#PUUPN

 

Always read the Pella® Limited Warranty before purchasing or installing Pella products. By installing this product, you are acknowledging that this Limited Warranty is part of the terms of the sale. Failure to comply with all Pella installation and maintenance instructions may void your Pella product warranty. See Limited Warranty for complete details at http://warranty.pella.com.

These instructions were developed and tested for use with typical wood frame wall construction in a wall system designed to manage water. These instructions are not to be used with any other construction method. Installation instructions for use with other construction methods, multiple units or bow and bay windows, may be obtained from Pella Corporation or a local Pella retailer, or by visiting http://www.pella.com. Building designs, construction methods, building materials, and site conditions unique to your project may require an installation method different from these instructions and additional care. Determining the appropriate installation method is the responsibility of you, your architect, or construction professional.

Image 1
Contents Part Number 80JJ0103 flashing tape or equivalent Rough Opening Preparation44USEUHIGH Pressureeor Latex Foams Cut the water resistive barrierAfter the doors have been installed in the rough opening Setting and Fastening the DoorExtend 6 up each side of the opening This time, label them and store them in a protected areaMeasurement from the interior face of the door Check the interior reveal. Make sureShipping spacers Out-swing doors Place a dab of sealant in each of the preShould Extend  Aboveethettopeof Shim and into the studDoor and 2 below the bottom Bottom of the doorApply top flashing tape. Cut a piece of flashing tape long Interior SealSide flashing tape to prevent water from getting Behind it Apply insulating foam sealant. From the interiorSealing the Door to the Exterior Wall Cladding Install the hardware. Refer to the instructionsIncluded INDTHEDHARDWAREEBOX Insert closed cell foam backer rod into the spaceInterior Finishing Care and Maintenance Important NoticeExterior Finish