7
Lift mounting neck to mounting Plate and align screws.
10
8
Secure mounting neck to the mounting plate with four screws to become a complete mount- ing bracket.
11
9
Remove keeper from cross pin and then cross pin from yoke. Replace keeper on cross pin and save.
12
| Loosen lock nuts and screws on yoke |
|
|
|
|
| |
|
| Loosen set screw that holds ball. | |
| till you can not feel screw on inside |
| |
| of yoke. |
|
|
|
|
|
|
|
|
|
|
Slide ball down and remove pin save pin for later.
13
Thread leadwires and safety cable through downrod.
16
14
Install downrod into yoke. Align hole in downrod with hole in yoke and install cross pin. Install keeper into cross pin.
17
15
Tighten 2 downrod set screws and lock nuts.
18
Install yoke cover over downrod onto | Install canopy onto downrod. |
fan body. |
Thread leadwires and safety cable through ball.