7
Lift mounting neck to mounting Plate and align screws.
10
Install 3 screws to hold glass to fan housing. Do not overtighten as this could crack the glass.
13
Install Keeper pin into all 3 cross pins.
16
Plug in electrical connection from Arch assembly to the fan body.
8
Secure mounting neck to the mounting plate with four screws to become a complete mount- ing bracket.
11
Spread 3 arch arms outward and place over the tabs on fan housing. Make sure the arm with the electrical connection plugs is next to the plugs on the fan housing.
14
While lifting upward on the arch arm assembly tighten the 2 set screws next to each cross pin where archs attach to the fan housing. These set screws can be loosened and adjusted once fan is in final position on the ceiling.
17
Loosen the 2 downrod set screws to allow downrod intallation to the yoke.
9
Lower upper glass disk onto fan housing and align 3 holes in glass with 3 holes in fan hous- ing.
12
Align hole in arch arm and hole in tab the fan housing. Do this for each of the 3 arch arms.
15
Install and tighten set screws for each arch leg located on the yoke.
18
Install canopy and yoke cover over the down- rod.