Points regarding the ‘Fire-bed’

•The stove is supplied with a ceramic matrix and coals/logs, which are to be arranged by the fitter in strict accordance with the installation instructions. The purchaser must not alter the layout of the coals/logs or add any extra coals/logs.

•The coals/logs used in this stove to produce a realistic coal/log effect are made from ceramic fibre based material. The ‘coals/logs’ may change colour after use, which is quite normal.

•Replacement ceramic matrices and coals/logs must be sourced from your approved Hunter Stoves stockist.

IMPORTANT NOTE:

It will take approximately 15-20 minutes for the firebed to take on its proper appearance of glowing coals and yellow flames.

Operating the Appliance

It is strongly recommended that these instructions are read and thoroughly understood in advance of operating this appliance.

Gas Control Cover Plate

To gain access to the gas control valve, the valve cover plate must first be opened. Hold the left-hand side of the cover and gently pull outwards. The valve cover is secured in place with a magnet.

Burner Controls

The gas control valve is situated on the left hand side of the appliance, looking from the front, next to the front left hand leg.

GAS CONTROL VALVE

Pilot Assembly

The pilot assembly is positioned at the front of the burner tray on the right hand side.

PILOT ASSEMBLY