Herrmidifier Co G-100ES manual To Inspect and Replace the Evaporator Pad

Page 10

Maintenance

To Inspect and Replace the Evaporator Pad:

It is recommended that the evaporator pad in the humidifier be replaced annually to maintain efficient operation. However, more frequent replacement may be necessary in areas of poor water quality.

1.Disconnect the power supply to the furnace.Turn OFF the water supply at the saddle valve by turning the valve handle clockwise.

2.Fully loosen the thumb screws at the bottom of the unit cover. The screws will remain attached to the cover. To remove the cover from the duct, pull the bottom away and then lift up. Put the cover aside for reassembly.

3.Remove the water distribution tray, located above the evaporator pad. It is held in place by a snap that must be lifted to pull out the tray.

4.Pull the evaporator pad and frame assembly away from the duct, being careful not to disturb the drain connection. Remove the old evaporator pad and discard.

5.Inspect the interior of the humidifier and remove any mineral deposits and accumulation from the frame assembly and drain tray.

6.Remove the new evaporator pad from the plastic bag and insert into the frame assembly, with the black spot facing up. Ensure that no part of the evaporator pad is outside of the frame. Return the evaporator pad and frame assembly to their original position inside the humidifier.

7.Check the distribution tray to ensure that holes are clear of any scale build up. If desired, the distribution tray can be washed with mild detergent and warm water.

8.Replace the distribution tray making sure the snap is hooked over the outside edge of the tray. Replace the cover and secure by tightening the thumb screws. Turn the water back on and reconnect power to the furnace.

End of Heating Season Shut Down:

1.Inspect and clean humidifier and components.

2.Turn water supply off at the solenoid valve.

3.Turn humidistat off.

8

Page 9 Page 11
Image 10
Page 9 Page 11
Contents 100ES Duct Mount Humidifier Table of Contents Introduction IntroductionSpecifications SpecificationsOperation This chart uses A.R.I. standard designationsCapacity Selection Guide Air Tightness of HomeRecommended Relative Humidity Levels Vs. Temperature Start UpInstallation Mounting Locations To Inspect and Clean the Conical Mesh Water Filter MaintenanceMaintenance of Your Humidifier To Inspect and Clean the Fluid RestrictorTo Inspect and Replace the Evaporator Pad End of Heating Season Shut DownTroubleshooting Humidifier is running all the time. Is this normal?Symptom Possible causes Corrective Action Description of Parts 100ES Assembly 351453-001 351453-011 Parts listDescription Part Number Unit Diagram Warranty Humidifier Limited Two Year Warranty

G-100ES specifications

The Herrmidifier Co G-100ES is an advanced humidification system designed to enhance indoor air quality and comfort in residential and commercial settings. This innovative unit boasts a number of standout features, technologies, and characteristics that make it a frontrunner in the humidification market.

One of the most impressive features of the G-100ES is its high-capacity water vapor output. With the ability to deliver a substantial amount of moisture, this humidifier effectively combats dry air during the winter months or arid environments, enhancing overall air quality. It is particularly beneficial for those suffering from respiratory issues or allergies, as maintaining optimal humidity levels can alleviate symptoms.

The G-100ES utilizes advanced ultrasonic technology, which allows for the efficient creation of fine mist without the use of heating elements. This not only conserves energy but also reduces the risk of burns, making it a safe option for households with children or pets. The ultrasonic process ensures that the humidity is distributed evenly throughout the space, creating a comfortable ambiance in every corner of the room.

Another key characteristic of the G-100ES is its user-friendly digital interface. The integrated display allows users to easily monitor and adjust humidity levels, set timers, or program specific humidity targets. It also features a humidistat that continuously measures the current humidity and automatically adjusts the output as needed, ensuring that indoor air remains at the desired level without constant intervention.

Additionally, the G-100ES is equipped with a large water reservoir, enabling extended use without frequent refills. The tank's design prioritizes ease of filling and cleaning, promoting hassle-free maintenance. The unit also employs a filterless design, reducing ongoing maintenance costs associated with replacing filters regularly.

Furthermore, the G-100ES is designed with quiet operation in mind, allowing it to run seamlessly in homes, offices, or other environments without causing disturbances. This makes it an ideal choice for bedrooms, nurseries, and workplaces alike.

In summary, the Herrmidifier Co G-100ES stands out in the humidification space with its high-capacity output, ultrasonic technology, user-friendly interface, spacious water reservoir, and quiet operation. It is a reliable solution for anyone looking to improve their indoor air quality and create a more comfortable living or working environment.
Top Page Image Contents