Operating Instructions

OPERATING INSTRUCTIONS cont.

Warning: Always unplug from electrical outlet before opening the dust cup (container).

Note: Dust cup filter must be used when operating the hand vacuum.

Assembling the Hand Vacuum

1.To open the dust cup (container), push the dust cup release button and pull out the dust cup. Verify that the dust cup filter is inside, then attach the dust cup (container) to the hand vacuum.

2.To attach the crevice tool or upholstery brush to the Hand Vacuum, push desired accessory into the suction hole, as shown below.

3.To use the flexible hose, push the end of the hose into the suction hole, then attach the desired accessory to the other end of the flexible hose, as shown below.

How To Operate Your Hand Vacuum

1.Hold the hand vacuum firmly in your hand by the Handle.

2.Push the On/Off Power Button to “On” position.

3.Start vacuuming.

CAUTION: The Hand Vacuum is a very powerful unit. Make sure that you hold it firmly, otherwise it can slip out of your hand and cause injury.

Cleaning & Changing the Dust Cup Filter

Warning: Always unplug the unit from electrical outlet before opening the Dust Cup (container).

Important: Do NOT use the hand vacuum without the dust cup filter in place.

Warning: After each Use - Always remove and empty the Dust Cup Filter.

1.To open the Dust Cup (container), push the dust cup release button and detach the Dust Cup (container). (Fig. 1)

2.Remove the dust cup filter. (Fig. 2)

Fig. 1

Fig.2

3.Empty the dust from the dust cup (container). (Fig. 3)

4.Rinse the dust cup filter in cold water and then wait 24 hours until it dries completely before replacing back into the dust cup (container).

(Fig. 4 & 5)

5.When the dust cup filter is completely dry, replace the dust cup filter carefully back into the dust cup (container).

6.Attach the dust cup (container) to the Hand Vacuum.

Fig. 3

Fig. 4

Fig. 5

CAUTION: The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged.

Please Note: The Dust Cup Filter is washable. It should, however, be replaced every three (3) months to ensure peak performance of your vacuum.

Important: Make sure that Dust Cup Filter is completely dry before re- installing back in the hand vacuum.