Fantom Vacuum FM742H instruction manual Replacing the Flat Belt

Page 15

REPLACEMENT INSTRUCTIONS

Caution: Be sure to turn the ON/OFF switch to the"OFF" position and disconnect the power cord from the wall outlet before replacing any of the parts below.

REPLACING THE FLAT BELT

Remove the bottom plate.

1 (refer to page 14)

Lift out the agitator assembly,and then remove the flat belt from the motor shaft and

2 the agitator pulley.

Motor Shaft

Flat Belt

Agitator Assembly

3 Place a new flat belt onto the motor shaft and pulley.

Motor Shaft

Flat Belt

Flat Belt

Pulley

Place the agitator assembly into the grooves in the nozzle head, making sure that the new

4 flat belt slides securely into the guide.

Bearing Holder

Groove

Nozzle Head

Reattach the bottom plate

5 (refer to page 14)

Caution:

Install the flat belt so that it has no twists in it,and so that all components turn smoothly.

13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents FM742H Page Read ALL Instructions Before Using this Vacuum Cleaner Important Safety InstructionsGrounding Instructions Frontrear Names of Each PartAttaching the handle Preparations Before USEInserting the Power Cord Plug Thermal Safety Device in Main BodyUsing the Vacuum Cleaner ON/OFF SwitchAdjusting the Handle RUG/FLOOR Toolsselector Edge CleaningUpholstery tool & Dusting brush Using the AttachmentsEmptying the Dust Compartment Power cord from the wall outlet before cleaningCleaning Utensil Cleaning the FiltersClearing Blockages and Cleaning the Agitator Assembly Replacing the Headlight Lamp Replacement InstructionsReplacing the Flat Belt Reattaching the Bottom Plate Removing the Bottom PlateReplacing the Filter Cleaning the SUB-FILTERProblem Cause Remedy TroubleshootingFive 5 Year Limited Warranty
Top Page Image Contents