Cleaning Method
➀Remove dust from the element with a vacuum cleaner, or rinse in cold or lukewarm
water. If the element is extremely dirty, wash |
|
with a neutral detergent. | FILTER |
➁After the element has been cleaned, rinse with clean running water, allow to dry, then reinstall.
In-Season/Off-Season Inspection & Maintenance
■In-Season
➀Check the prongs and surface of the power cord plug for dust and/or dirt. If dust and/or dirt are present, wipe off with a clean, dry cloth.
➁Check the power cord, plug and prongs for damage or excess play. If any dam- age or excess play is found, contact your MovinCool reseller for repair.
➂Check the air fi lters and drain tank.
➃ Clean the outside of the unit(s) with a damp cloth or mild nonabrasive cleaner.
■Off-Season
➀ Operate the unit in Fan Only mode for 8 hours.
Note: Operation is necessary to dry out the inside of the unit.
➁Disconnect the power cord from the AC outlet.
➂Check the prongs and surface of the power cord plug for dust and/or dirt. If dust and/or dirt are present, wipe off with a clean, dry cloth.
➃Check the power cord, plug and prongs for damage or excess play. If any dam- age or excess play is found, contact your MovinCool reseller for repair.
➄Clean the air fi lters.
➅Empty all water from the drain tank.
TROUBLESHOOTING
Office Pro 36 Self-Diagnostic Codes
conditions:
dF | When the evaporator freezestat disengages the |
| compressor. |
FL | When the drain tank switch shuts off the unit (FULL |
| TANK LED fl ashes). |
AS | When unit disengages the compressor while the |
| condensate pump is discharging water. |
HP | When the high pressure switch disengages the |
| compressor. |
LO | Lowest temperature set point. |
Note: If AS does not disappear from display, contact your distributor.
9