Trouble Shooting, Problem, Cause | Brada Appliances YPL3-10C

End of season ·Please drain the water.

·Keep the unit running in Fan mode for two hours until the inside of the unit is dry. ·Turn off the unit and unplug it.

·Clean the air filter and after dry it thoroughly, reinstall it. ·Remove the exhaust pipes and keep them carefully.

·Wrap the unit with the plastic bag and keep it in a dry place.

TROUBLE SHOOTING

Before contacting professional service, check it first yourself referring to the followings:

Problem	Cause	Solution
	No power supply.	Connect to power supply outlet and
The air	No power supply.	switch on.
The air		switch on.
conditioner	“FL” flashes on the display	Drain water.
does not	screen	Drain water.
does not	screen
function.
function.	Timer-off is running.	You can turn on the unit three minutes
	Timer-off is running.	later.
		later.
	In direct sunlight.	Close curtains.
The air	Windows or doors open, many	Close doors and windows, remove the
conditioner	people or a heat source in the	Close doors and windows, remove the
restart	room.	heat source.
restart	room.
frequently	Dirty filter.	Clean or replace the filter(s).
	Air inlet or air outlet blocked.	Remove the blockage.
The unit is too	Unit stands uneven.	Place on an even, solid surface (less
noisy	Unit stands uneven.	vibration).
noisy		vibration).

No work of	Self protect of compressor	Wait for 3 minute and restart again
compressor	Self protect of compressor	after the descend of temperature
compressor		after the descend of temperature

Cautions: Switch off the unit and unplug it immediately if anything abnormal happens. Then contact a qualified electrician.

Above data without advance notice for product improvement.