Cleaning
In sleep mode operation, if indoor purification(pollution level 1) continues on for more than the specified time period(app. 1 hour), motor is automatically stopped to minimize power consumption.
What Is Sleep Mode Operation?(Available only automatic mode and yellow dust mode)
●Using CDS sensor to detect brightness in the surrounding area, operation mode is automatically converted to nighttime noise- controlled mode
(airflow level 1).
●Sleep mode operation is automatically |
| � |
cleared when manual mode is selected |
| |
or brightness of the surrounding area |
| |
|
| |
increases. |
|
|
|
|
|
Particle Sensor
(Upon product shipment, particle sensors are adjusted to normal level. When the level of pollution remains at its height even after running the air purifier for more than 2 hours in highly polluted conditions or when it maintains lowest level for more than an hour even in highly polluted conditions, use the following methods to adjust the sensor before use..)
�Press both select "SWING/ION" and "SPEED" buttons at the same time for 2~3 seconds while the unit is in operations.
�The "DUST" indicator at the front of the product flickers.
�Press "SPEED" button and adjust to desired sensor mode. Sensor level will be displayed on the dust pollution display panel.
Sensitive | Average | Insensitive | � |
| |||
level 1 | level 2,3 | level 4 |
|
21
Always make sure to unplug power cord prior to filter cleaning.
�Select desired sensor level and press select "SWING/ION" and "SPEED" buttons at the same time for 2~3 seconds. The display panel will then resume normal operations and sensor level will be displayed accordingly
When no buttons are selected for 10 seconds, the corresponding value will automatically be given.
Cleaning of Dust Pollution Detection Sensor(To be cleaned once every 2 months)
●First of all, open the cover of the contamination | Blowhole | |
| ||
detecting sensor on the right side of the product | � | |
Clean the air inlet, outlet, and around the dust | ||
contamination detecting sensor with soft brush | ||
| ||
or vacuum cleaner. |
| |
| Suction Hole |
●Second of all, clean the lens, dust inlet, and the dust outlet with wet cotton swab, and then remove water with dry one.
If it is not cleaned periodically, it can be a major cause
of the performance deterioration of the dust contamination detecting sensor.
The cleaning period is subjective to the air cleaner using environment, thus, clean it more frequently if the cleaner is used in a dusty area.
Cleaning of Filter Cover
●Remove dust from surface with vacuum cleaner or soft brush, etc.
In case of severe pollution, wash filter cover with clean water and completely dry it before use.
22
Caution
How to Use Self Diagnosis Customer Service