Jenn-Air W10574732A Installation Requirements, Tools and Parts, Location Requirements

Page 3

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed

■

Tape measure

■

Pliers

■

Flat-blade screwdriver

■

¼" drill bit

■

Phillips head screwdriver

■

Jigsaw

■

Drill

■

Ratchet with ³⁄₈" socket

■

Level

■

Pipe-joint compound

■ 6" (15.2 cm) socket

 

resistant to LP gas

 

 

 

extension

■

Noncorrosive leak-detection

■

Marker or pencil

 

solution

 

 

Parts supplied

■

Vent grill

■

Burner caps

■

Pre-filter

■

Burner grates

■

LP conversion kit

■

Pressure regulator

Parts needed

■Metal ducting

■Vent clamps

■Jenn-Air wall cap

Jenn-Air®6" (15.2 cm) Round Surface Wall Cap Damper Order Part Number A406

Jenn-Air®3¼" x 10" (8.3 x 25.4 cm) Surface Wall Cap Damper Order Part Number A403

To order, see the “Assistance or Service” section of the Use and Care Guide.

Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See “Electrical Requirements” and “Gas Supply Requirements” sections.

It is recommended that all electrical connections be made by a licensed, qualified electrical installer.

■All openings in the wall or floor where cooktop is to be installed must be sealed.

■Cabinet opening dimensions that are shown must be used. Given dimensions are minimum clearances.

■Grounded electrical supply is required. See “Electrical Requirements” section. Proper gas supply connection must be available. See “Gas Supply Requirements” section.

■The cooktop is designed to hang from the countertop by its side or rear flanges.

■The gas and electric supply should be located as shown in “Cabinet Dimensions” section so that they are accessible without requiring removal of the cooktop.

■Provide cutout in right rear corner of cabinet enclosure as shown to provide clearance for gas inlet, power supply cord, and to allow the rating label to be visible.

■If cabinet has drawers, drawers will need to be removed and drawer fronts installed on front of cabinet.

IMPORTANT: An undercounter built-in oven cannot be installed under this product.

IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This cooktop has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C).

Mobile Home - Additional Installation Requirements

The installation of this cooktop must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When such standard is not applicable, use the Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes.

■In Canada, the installation of this cooktop must conform with the current standards CAN/CSA-A240-latest edition, or with local codes.

Product Dimensions

30" (76.2 cm) Cooktop

Location Requirements

IMPORTANT: Observe all governing codes and ordinances. When installing cooktop, use minimum dimensions given.

■It is the installer’s responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on side of the downdraft plenum.

■To eliminate the risk of burns or fire by reaching over the heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets.

■The cooktop should be installed in a location away from strong draft areas, such as windows, doors and strong heating vents or fans.

A

B

C

A. 21½" (54.6 cm) B. 19¹¹⁄₁₆" (50.0 cm)

C. Model/serial rating plate location

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Cooktop Safety Cooktop Installation InstructionsWhat to do if YOU Smell GAS Installation Requirements Tools and PartsLocation Requirements 36 91.4 cm Cooktop Cabinet DimensionsFor Best Performance Cutout DimensionsCold Weather Installations Venting RequirementsOption 1 Roof Venting Option 2 Wall Venting Concrete Slab Installations Exhaust Through WallJenn-AirDuct Free Filter Accessory Kit Venting MethodsVent Piece Cm Round Electrical RequirementsCalculating Vent System Length Example vent systemGas Pressure Regulator Gas Supply RequirementsType of Gas Gas Supply LineRotate Blower Optional Installation InstructionsInstall Cooktop Gas Supply Pressure TestingTo rotate blower motor Make Gas ConnectionComplete Connection Typical flexible connectionElectronic Ignition System Complete InstallationVotre sécurité et celle des autres est très importante Sécurité DE LA Table DE CuissonExigences Dinstallation Exigences demplacementOutillage et pièces Table de cuisson de 36 91,4 cm Dimensions du produit Table de cuisson de 30 76,2 cmDimensions du placard Dimensions de l’ouverture à découperExigences concernant lévacuation Air d’appoint Installations pour régions à climat froidMéthodes dévacuation Pour obtenir la meilleure performanceComposant Conduit de diamètre de 15,2 cm Coude à Pi 0,8 m Trousse accessoire de filtration sans conduit Jenn-AirCalcul de la longueur effective du circuit dévacuation Exemple de circuit dévacuationGaz naturel Spécifications électriquesSpécifications de lalimentation en gaz Type de gazTest de pressurisation de la canalisation de gaz Canalisation de gazDétendeur de gaz Caractéristiques dalimentation du brûleurPour faire pivoter le ventilateur Instructions D’INSTALLATIONInstallation de la table de cuisson Rotation du ventilateur FacultativePour faire pivoter le moteur du ventilateur Raccordement au gazAchever le raccordement Raccordement typique par raccord flexibleAllumage initial et réglages des flammes de gaz Achever linstallationSi vous avez besoin d’assistance ou de service Système dallumage électronique

W10574732A specifications

The Jenn-Air W10574732A is an innovative appliance designed to revolutionize your culinary experience with impeccable performance and cutting-edge technology. One of the standout features of this appliance is its sleek design, making it an elegant addition to any modern kitchen. Its stainless steel finish not only adds to the aesthetic appeal but also ensures durability and easy maintenance.

This model is equipped with advanced temperature management technology, which allows for precise control over cooking temperatures. This feature is crucial for achieving perfect results for various recipes, from delicate pastries to perfectly seared meats. The oven's even baking technology ensures that heat is distributed evenly throughout the cooking space, eliminating hot spots and allowing for consistent results every time.

One of the key characteristics of the Jenn-Air W10574732A is its versatility. It combines multiple cooking options, including convection cooking, which circulates hot air to cook food faster and more evenly. This method not only saves time but also enhances the flavors of the dishes prepared. The appliance is also compatible with smart technology, providing users with the ability to monitor and control cooking settings remotely through a smartphone app. This feature offers convenience and flexibility, allowing users to manage their cooking schedules more effectively.

Furthermore, the Jenn-Air W10574732A comes with a self-cleaning function, which simplifies maintenance and upkeep. This feature uses high temperatures to eliminate food residues and grime, saving users time and effort in maintaining a clean oven. The control panel is user-friendly, featuring intuitive controls and clear displays, making it accessible for all levels of cooks.

Safety is a significant consideration in any kitchen appliance, and the Jenn-Air W10574732A incorporates features such as automatic shut-off and cool-touch door technology, ensuring a safe cooking environment. Its spacious interior provides ample room for multiple dishes, making it an excellent choice for those who enjoy hosting gatherings or preparing meals for larger families.

Overall, the Jenn-Air W10574732A stands out as a top-tier appliance that marries style with functionality. Whether you are an amateur cook or a seasoned chef, this oven promises to elevate your culinary creations with its multifaceted features and innovative technologies, making it a worthwhile investment for any modern kitchen.
Top Page Image Contents