Magnetic Stripe Reader Option | POSIFLEX Business Machines KP-300

each marked as “PRG”, “REG”, “Z” and “GT”. The effective range of each of the 4 keys can be illustrated by the following table and drawing.

LP L0 L1 L2 L3 L4

PRG REG		Z	GT
Y	N	N	N
Y	Y	Y	Y
Y	Y	Y	Y
Y	Y	Y	Y
Y	N	Y	Y
N	N	N	Y

Programmable Keys

The multi-page programmable keys can deliver to the host system the string of keyboard input as programmed. Please note that when the 6 position electronic control key is turned to a different position, the content of same key could be completely different. It is also possible to use combination keys if programmed to. There will be no output of these keys if the control key is turned to “L0” position.

Numerical Keypad

The numerical keypad is durably pre-marked. When the 6 position electronic control key is turned to a different position, the content of same key remains unless it has been programmed in a particular way. The numerical keypad is not applicable in combination keys. There will be no output of these keys if the control key is turned to “L0” position.

MAGNETIC STRIPE READER (OPTION)

For magnetic stripe card reading, be sure to insert the card to the bottom with magnetic stripe facing the mark aside the slot. The movement of the card can be either inserting the card from the top surface then sliding the card down out of the slot, or sliding the card upward from the lower side of the slot till it reaches the top end as long as the card is a standard one. A non- standard card recorded without complete degaussing prior to recovery may accept only one direction in card reading.

The magnetic stripe reader in KP-300 / KP-300T connects to the host through USB port as an USB KB and therefore requires no driver installation to get it working.

SMART CARD READER (OPTION)

Card Insertion

For smart card reading, please insert the end of the smart chip first and have the chip facing upward and toward the mark aside the side slot of KP-300 as in the example picture in front right side view.

Part 8