MAINTENANCE AND CARE
2.Replacing the Power Nozzle Belt IMPORTANT: Before performing any maintenance work on the power nozzle, always unplug the vacuum cleaner and disconnect the wand.
To replace the power nozzle belt, you must first remove the brushroll (see "Removing the Brushroll"). Locate and discard broken belt.
To install new belt, locate the power nozzle motor pulley and loop the belt around it (see diagram 12). Place the other end of the belt around the brushroll making sure the belt is seated in the "belt groove" of the brushroll (see diagram 13). Insert the brushroll back into the brushroll tray and place the belt guard back into position (see diagram 11). Place the metal bottom plate back onto the unit (insert the front end of the bottom plate first). Re- insert the two bottom plate screws and secure.
Belt
3.Replacing the Bulb
IMPORTANT: Before performing any maintenance work on the power nozzle, always unplug the vacuum cleaner and disconnect the wand.
Turn the power nozzle over and remove the bottom plate by first unscrewing the two bottom plate screws located by the rear wheels (see diagram 10). Locate and remove the two top cover screws (see diagram 14). Turn the power nozzle back over, push the power nozzle neck flat, and remove the top cover (see diagram 15). Simply pull the bulb out (no twisting) and reinsert a factory- authorized bulb. Place the top cover back on the unit, turn the machine over and
Top Cover
Screw
Diagram 12 | Diagram 13 | Diagram 14 | Diagram 15 |
8