FEATURES
PRODUCT SPECIFICATIONS:
CHARGER | Item No. 7222701 |
HAND VAC | VC722 | BATTERY | Item No. 1311145 | |
Charger Rating | 120V, 60 Hz, AC Only | |||
Motor | 7.2 Volt, DC | |||
Switch | On/Off | Charger Voltage | 7.2 Volt | |
|
| Charger Rate |
OPERATION
WARNING:
If any parts are missing, do not operate unit until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
CAUTION:
To prevent damage to battery pack, remove battery pack from charger immediately if no LED comes on. Return battery pack and charger to your nearest Ryobi Authorized Service Center for checking or replacing. Also, if you are removing battery pack from charger and no LED is on, return both battery pack and charger to your nearest Ryobi Authorized Service Center. Do not insert another battery pack into charger. A defective charger may damage a battery pack.
CHARGING YOUR HAND VAC
The battery pack for your hand vac has been shipped in a low charge condition to prevent possible problems.There- fore, you should charge it overnight prior to use.
NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (vacuuming fol- lowed by recharging) for them to fully charge.
■Charge only with the charger provided.
■After normal usage, 3 hours or less of charging time is required to fully recharge hand vac. NOTE: If hand vac is completely discharged, 6 hours or longer of charging time is required to fully recharge battery.
■While charging, it is normal for the charger to become warm to the touch.
■Do not place charger in an area of extreme heat or cold. It will work best at temperatures above 50°F and below 100°F.
TO CHARGE HAND VAC’S BATTERY PACK WITHOUT USING CRADLE
See Figure 2.
■Charge hand vac only with the charger provided.
■Insert charger plug into input jack of battery pack making sure it is properly connected. See Figure 2.
■Make sure power supply is normal household voltage, 120 volts, 60 Hz, AC only.
■Connect charger to power supply. The LED indicator, will light up when charger is properly connected to power supply. This light indicates that proper charg- ing is occuring. It will remain on until charger has been disconnected from power supply.
CHARGER
BATTERY
PACK
CHARGE
INDICATOR
LIGHT (LED)
CHARGER PLUG
INTO INPUT JACK
Fig. 2
7