HOW to USE

CAUTION: Moving parts. Make sure on/off switch is in off position before plugging in.

A carpet should be cleaned regularly over heavily traveled areas, and once a week over the entire carpeted area. Vacuum slowly, making several passes (forward and backward) over the carpet, covering small areas at a time. The time required to clean the carpet will depend on several factors–including type of carpet and amount of dirt.

5Push ON/OFF Switch

(A thermostat automatically shuts the motor off if it overheats, see Automatic Motor Shut-Off)

ON/OFF Switch

1 Connect Hose

2Rotate Swivel Hook to release cord

3Plug In

Swivel Hook

4Store Tools

Crevice Tool

HEPA

Filter

(on some

models)

Automatic Motor Shut-Off

To protect from overheating, this vacuum cleaner is equipped with a thermostat which automatically shuts off the motor if it overheats. Should this happen:

1.Turn off the switch and unplug the cleaner because the thermostat will allow the cleaner to automatically start running again when the motor cools (approximately 30 minutes).

2.Check the hose, bag and ﬁlter regularly, as a clogged hose, full bag or dirty ﬁ lter could cause the motor to overheat.

3.Call a Eureka Service Station if the cleaner will not operate after cooling for approximately 30 minutes.

Cleaning Accessories

Attach wands and cleaning tools

(Wands may vary by model)

Open the Slip Ring to reduce suction.

Tool Caddy

Combination

Floor Tool