Sanitaire S647 Vacuum Cleaner Assembly Manual

HOW TO ASSEMBLE

CAUTION: Completely assemble vacuum cleaner before using.

Assembly Packet is with ownerʼs guide.

A	B	C	D
2-Part	Upper	Lower	Bag
Bolt	Cord Hook	Cord Hook	Screws

Step 1

Attach the Handle

Push the handle sections together. Note: Check to be sure slots in handle are correct, see Detail A.

Align the holes in the handle. Insert a 2-part bolt (A) in the center of the handle and tighten.

Push handle into the handle socket so handle grip curves away from the cleaner. Align the holes, insert the other 2-part bolt (A) and tighten.

Step 2

Attach Upper Cord Hook

Pull the flexible cord support up toward the top of the handle.

Insert the lower half of the cord support into the upper cord hook.

Check to be sure slots in handle are correct, see Detail A. Place inner tab of cord hook into handle slot as shown (1) and press hook handle (2) SNAPPING opposite inner tab into place (3).

Flexible

SCord

Support

Upper Cord Hook

1. Place inner	2. Press hook	3. SNAP opposite
tab into slot	around handle	inner tab into
		place

Step 3

Attach Lower Cord Hook

Insert the power cord into the lower cord hook. Snap the hook into the lower handle.

Pull up on the cord to tighten but leave enough slack near the base so there is no strain on the cord when the handle is lower.

Lower Cord Hook

Step 4

Store Electrical Cord

Wrap the cord around the two cord hooks. Fasten the plug to the electrical cord to prevent unwinding.

Step 5

Attach Outer Bag

IMPORTANT: To provide a good gasket seal, the bag

Acoupling must seat ﬁrmly against the motor base and not overlap the furniture guard.

Hold outer bag with zipper away from the handle. Start the bag screws (D) by hand, then tighten with a screwdriver.

Loop the bag spring onto the bag support hook on the back of the upper cord hook.