Tamper Alarm Lockout

Latching Authorization

Placing jumpers across the 4th Ex: Latching Authorization and 5th set of pins (1,2 LATCH

or 3,4,5 LATCH) determines which relay (if any) each User Group is authorized to manually latch.

How to Latch

When a valid code is entered on the keypad followed by “7”, the Latch

Authorization relay for that particular User Group will energize and remain energized until a valid code followed by “7” is entered again.

Example:

1.Placing a jumper across the 1st and 2nd pins of the “1, 2 LATCH” option allows User 1 and User 2 to Latch Relay #2.

2.Leaving a jumper off the “3,4,5 LATCH” option prevents User 3, User 4 and User 5 from latching either relay.

Note: Because the Master Code is primarily used to program User codes, the Master Code does not have Latching Authorization.

CCTV/Doorbell Setup

Placing jumpers across the 6th or Ex: CCTV Setup 7th set of pins (CCTV or

DOORBELL) determines which relay (if any) will be used to activate a CCTV or Doorbell.

CCTV Operation: If either relay is configured to activate a CCTV, any key press on the Keypad triggers a 10 second output.

Doorbell Operation: If either relay is configured to activate a doorbell, pressing ∗ at the Keypad triggers a 1 second output. (Doorbell only functions with 12-Pad 3x4 or Thinline 2x6)

2nd Door Operation The KE-265 has been

designed to provide 2 door Ex: 2 Door Configuration operation with one or more

Keypads. With this configuration, certain codes will activate Relay #1 and certain codes will activate Relay #2. (Connect Relay #2 to the 2nd Locking Device)

Example:

1.Placing a jumper across the 2nd and 3rd pins of the “MASTER UNLOCK” option allows the master code to activate (unlock) Relay #1.

2.Placing a jumper across the 2nd and 3rd pins of the “1,2 UNLOCK” option allows User Code 1 and User Code 2 to activate (unlock) Relay #1.

3.Placing a jumper across the 1st and 2nd pins of the “3,4,5 UNLOCK” option allows User Code 3, User Code 4 and User Code 5 to activate (unlock) Relay #2

4.In this example, User Code 1 and User Code 2 have also been given Latching Authorization for Relay #1.

Note: In order for 2 Door configuration to operate correctly, be sure to remove any jumpers across the CCTV option and the Doorbell option.

A person attempting to gain entry by guessing the code and pushing 25 wrong digits will cause the KE-265 to go into tamper alarm mode. The Keypad will beep constantly for 30 seconds during which time the door will remain locked and no keypad functions can be performed.