appliance with double insulation, it does not need to be earthed.
3.Turn the thermostat control to the maximum position.
4.Select the desired power (1000W - 2000W).
5.When the room has reached the desired temperature, turn the thermostat control slowly
anticlockwise until the appliance switches off, with a gentle “click”. From now on, the heater will switch on and off automatically, maintaining the room at a constant tempe- rature.
6.To switch the appliance off, set the power selector control to the O position.
Maintenance
1.Disconnect the appliance from the mains electrical supply befo- re carrying out any maintenance work.
2.After any prolonged period of non operation, we would advi- se to clean away the dust that has accumulated inside by applying ideally using jet of compressed air through the air inlet and outlet grid. This clea- ning operation should be carried out by a suitably quali- fied technician.
3.We would always recommend to regularly clean the air inlet and outlet grids.
4.Do not immerse the appliance in water or hold it under the tap.
5.Do not dismantle or interfere with the appliance, to do so would invalidate the guarantee.
6.If you detect any anomaly, con- tact the extensive S&P Official Service Network.
Note: It is very important to clean the appliance thoroughly at least once a year. In this way possible risks of accident are reduced.
Disconnection due to overheating
In the instance that the unit over- heats, the thermal overload pro- tection system operates which then automatically disconnects the electrical parts on the applian- ce from the mains electrical supply. In such an event, proceed as follows:
Disconnect the appliance from the power supply; let it cool down for 15 minutes, clean the inlet and outlet grid (ideally with a vacuum cleaner). If the appliance still fails to work normally after these steps have been taken, please contact the S&P Official Service Network.
IP21 230V ~ 50Hz 2000W
5