CLEANING INSTRUCTIONS
ENGLISH
WARNING:
FIRE HAZARD
Shut off the gas
supply valve before cleaning.
CAUTION:
BURN HAZARD
Allow hotplate to cool completely before cleaning.
IMPORTANT: DO NOT spill or pour water into controls,
DO NOT submerge hotplate cabinet in water. Damage to internal components will occur.
Damage to internal components from water damage is NOT covered by warranty.
DO NOT steel wool or metal scouring pads to clean cabinet, drip tray or crumb tray.
Good sanitation is vital to the quality of the final food product. Be sure to clean in all corners and crevices where grease and other cooking debris can accumulate.
PREPARATION
Turn gas
Allow hotplate to cool completely before cleaning.
FREQUENCY
Daily
TOOLS
Bristle Brush
Clean Cloth or Sponge
Mild Detergent
Cleaner Formulated for Stainless Steel
Warm Water
CLEANING
Turn gas
Note position of front and rear burner assemblies in cabinet. Remove burner assemblies.
Clean food particles from grate drip tray with warm water, mild detergent and a bristle brush. Rinse with clean water. Wipe dry with a soft clean cloth.
Examine burner assemblies. Note position of air shutters before cleaning. Clean food particles from burners with warm water, mild detergent and a bristle brush. Rinse by wiping with a soft cloth dampened with clean water. Wipe exterior surfaces dry with a soft clean cloth. Allow burners to air dry so that interior passages are completely free of water.
Wipe the outer portions of the hotplate cabinet with a clean soft cloth or sponge dampened with warm water and a mild detergent or cleaner formulated for cleaning stainless steel. DO NOT use steel wool to clean hotplate cabinet. Rinse by wiping hotplate cabinet with a clean soft cloth or sponge moistened with clean warm water. Dry cabinet by wiping with a clean soft dry cloth.
Examine burners to be sure the air shutters are in their proper position. Reinstall burner assemblies in cabinet (see fig. 5, page 11):
Burner with short venturi tube is the front burner. The venturi / air shutter slides over the nozzle of the right control valve. The pegs on the bottom of the burner set in corresponding notches at the front of the burner support bracket.
Burner with long venturi tube is the rear burner. The venturi / air shutter slides over the nozzle of the left control valve. The pegs on the bottom of the burner set in corresponding notches at the rear of the burner support bracket.
Turn
Procedure is complete.
226 306627 OpManual for
10