SCRUB DECK/BRUSH
MOTOR
1. Remove (4) screws holding motor shroud.
7.Squeegee tracking can be controlled by adjustin tension of squeegee springs. NOT%: Position recovery hose as shown before making adjustments.
4.Disconnect motor leads from terminal block.
5.Remove (4) screws holding brush motor to scrub deck.
2. Remove batteries and squeegee as- sembly. Lay machine on side.
3. Remove center screw holding drive plate. Slide drive plate off motor shaft.
WHEELS/CASTERS
1. Use allen wrench to remove wheel retaining screw.
Brush Motor
6.Remove (2) motor
2.Use arbor press to replace bearings as required. Use grease gun to lubricate bearings through zerk fitting on wheel hub and caster axle.
SOLUTION STRAINER
1. An inline solution strainer is located under chassis behind left wheel. Re- move sediment bowl and screen period- ically and rinse clean with hot water.
Limited Warranty: Windsor Industries warrants that the Windsor machine covered by this warranty is free from defects in workmanship and materiqls under the following terms:
6 YEARS On Rotationally Molded Polyethylene Tanks.
3 YEARS On Traverse Drive Motors, Gear Units, AC Induction Polisher Motors, all Metal Chassis and Metal Frames.
1 YEAR: On all other parts which are not specifically referenced herein, plus an extra year (2 years total) on Rectified DC Polisher Motors and Scrubber Brush Motors.
The warranty period shall commence at the date of FIRST PURCHASE BY THE END USER FROM AN AUTHORIZED WINDSOR DISTRIBUTOR and applies to defective parts only, not to failure caused by abuse or normal wear.
Windsor will, at its option, repair or replace without charge, except for normal transportation costs, parts that fail under normal use and service when operated and maintained in accord- ance with the Owners Instruction Manual and the Preventive Maintenance Guide where applicable. This warranty shall apply to defects in material and workmanship only and does not apply to: a) transportation damages, b) alterations by unauthorized persons,
c)misuse or abuse (including use of incompatible or corrosive chemicals or overloading of capacity), d) failure caused by lack of proper maintenance and cleaning, e) batteries and chargers which are warranted by the original manufacturer for one year, and f) normal wear on items such as belts, brushes, bearings, capacitors, carbon brushes, clutches, cords, filters, finishes, gaskets, hoses, pulleys, relays, rectifiers, and switches.
The warranty is in lieu of all warranties, expressed or Implied, and releases Windsor from all other obligations and liabilities. It is applicable only in the U.S.A., Canada, Australia, and New Zealand. Windsor Industries is not responsible for costs of repairs performed by persons other than those specifically authorized by Windsor. This warranty does not apply to damage or loss of income due to malfunctloning of the machine. USE OF PARTS NOT APPROVED BY WINDSOR WILL VOID WARRANTY.
If a difficulty develops with this machine, contact either the Dealer from whom you purchased the product or write to:
6