Whynter ARC-10WB instruction manual Installing Batteries, Button Function, Led

REMOTE CONTROL

The portable air conditioner can be switched on by the remote control. To transmit signals from the remote control to the air conditioner, point the front part of the remote handset towards the control panel on the air conditioner. Reception of the signal is confirmed by a beep. The maximum signal transmission distance is approximately 8 meters / 26 feet.

NOTE:

∙Other appliances in the same room controlled by a remote control (TV, radio, stereo, etc.), may cause interferences.

∙Electronic and fluorescent lamps may interfere with the signal transmissions between the remote control and the air conditioner.

∙Remove the batteries if the remote control is not used for long periods.

INSTALLING BATTERIES

∙Only use two dry LR03 AAA 1.5V Batteries (included) in the remote control.

∙Always change both batteries at the same time.

To insert the batteries, open the flap on the back of the remote control by sliding if off. Strictly adhere to the polarity signs on the bottom of the battery housing, close the flap once the batteries have been inserted.

Button	Function
On/Off	Turns the unit on and off.
Mode	Controls the 4 function modes:
	Auto, Cool, Dry & Fan.
Fan Speed	Controls the 3 fan speeds: Auto
	High, Medium & Low.
Timer On	Enables the On timer & set timer
	hours.
Timer Off	Enables the Off timer & set timer
	hours.
Temp Up	Increases set temperature.
Temp	Decreases set temperature.
Down
Swing	Starts or stops louver movement
	and set louver angle.
Economy	Enables sleep mode.
Reset	Cancels all settings.
Lock	Locks all settings
LED	Turns on the display light.
Display

17 P a g e