Global Machinery Company VEC158-AU instruction manual Replacing the spotlight

F

G

K

L

H I

Replacing the spotlight

To replace the H3 type 12 volt bulb, you will need a small Phillips type

screwdriver and aJ replacement bulb (GMC

Part VEC120-AUBUL). Bulb life can be shortened

by installing a bulb with dirt or fingerprints on it.

The bulb can be wiped clean with a cloth moistened with alcohol. During bulb installation, avoid touching the glass part of the bulb.

1.Disconnect the unit from any charging adapters.

2.Pull the rubber bezel away from the front of the spotlight to reveal two small Phillips screws in the wide retaining ring. The screws are on opposite sides of the ring (fig. F).

3.Using the screwdriver, remove (counter-clockwise) the two screws and set them aside (fig. G).

4.Lift off the retaining ring, glass lens and rubber “O” ring and set them aside (fig. H & I).

5.Carefully remove the reflector and bulb assembly (fig. J).

6.On the failed bulb, disconnect the bulb wire from the red power wire.

7.Unsnap the hairpin retaining wires from the reflector’s flange (fig.K).

8.Using the screwdriver, loosen the retaining screw to remove the bulb from the reflector (no need to completely remove this screw) (fig. L).

9.Lift out the bulb and the attached wire (fig. M).

M

11