Charging your cell phone

• If your unit is com-
pletely		drained of		energy,
you	should		pull	the	RIP
CORD		again	three	to five
minutes. Keep in mind, that
if the		Forever Flashlight
Rip Cord has not been uti-
lized for a long length of
time, it will cause the bat-
tery life to be shorter than
normal even after recharg-
ing.
In this case, recharge the
battery		by pulling		the	RIP
CORD for three to five min-
utes. This will allow the
internal rechargeable					bat-
tery to reactivate and charge
completely.			charging		by
•	While
using the RIP CORD, remem-
ber to turn the unit off.
• If you utilize and pull
the			slowly,		the

properly. The recommended pull speed would be 80 pulls per minute.

Charging your unit using an AC/DC adaptor.

Simply turn off your unit and use your DC

located on the sideINPUTof yourJACK unit, connect an AC/DC adaptor cord and then plug into an electrical outlet. Your built-in batter- ies will be fully charged within three hours. Do not leave plugged into an outlet for more than 24 hours. This will damage your internal rechargeable batter- ies.

Using the flashlight Your Forever Flashlight

Rip Cord includes an ultra

This energy saving light uses minimal power con- sumption. To use the flash- light, first, set the LIGHT

SWITCH to either LIGHT/OFF/ SIREN/BLINK. The choice between LIGHT, OFF, SIREN,

and BLINK, will adjust the features of the flashlight.

The LIGHT switch will allow a super bright 5 LEDS light to brighten your path.

The SIREN switch will allow a loud emergency siren signal. At the same time this will allow the LED light to BLINK. What a great feature for when you are in need of help.

To turn off the flashlight, switch the LIGHT SWITCH to

OFF.

Your Forever Flashlight Rip Cord also has a great additional feature –you can charge your cell phone (or other electrical items with low voltage) anywhere you are located. For best results, follow these steps in charg- ing your phone:

1. Pull your Forever Flashlight Rip Cord for one minute prior to plugging your phone charge cord in.

2. Connect the phone charge cable into the DC OUTLET JACK. This is locat- ed on the side of the unit. See page 4 for the location

of the CELL PHONE CHARG-

ING OUTPUT.

batteries can not be charged

RIP CORD

8 bright 5 LEDS light.