Kenmore 251.50701 manual OPTION1.EMPTYING Manually, Cleaning the Exterior, Cleaning the Bucket

OPTION1.EMPTYING MANUALLY

1.Pull out the bucket, grasping side handles.

2.Carry the bucket by grasping the inside handle of the bucket.

3.After emptying the bucket, replace the bucket in the dehumidifier.

NOTE: Dehumidifier will not work when the BUCKET FULL light is on or without the bucket properly placed in the unit.

OPTION 2, GRAVITY DRAIN HOSE (Hose Not Provided)

1.Take off GRAVITY DRAIN Cap. (Fig. 1)

2.Assemble the DRAIN CONNECTOR to the dehumidifier by turning clockwise. (Fig.2)

3.Next, Screw a standard drain hose to drain connector by turning clockwise. (Fig.3)

_WARNING

•Disconnect power supply cord from receptacle before performing any maintenance.

CLEANING THE EXTERIOR

Clean the exterior using a soft brush or dry towel. But do not spray water directly on the exterior.

Fig.1

Fig.2

Fig.3

Fig.lFig.2

Fig.3Fig.4

Fig.5

CLEANING FRONT GRILL AND AIR FILTER

1.Remove the bucket from unit. Air filter is located behind front grill. (Fig.l)

2.Pull the filter down and away from unit until it is all the way out. (Fig.2)

3.Wash with mild detergent. Rinse thoroughly. Air dry away from direct sunlight. (Fig.3)

4.FRONT GRILL can be cleaned using a vacuum cleaner or a soft brush to remove

dust. (Fig.4)

5.After cleaning, assemble the air filter to front grill. (Fig.5)

NOTE : Check your filter periodically to insure proper operation.

CLEANING THE BUCKET

Remove the bucket from the unit. Lift off bucket cover. (Fig. 1) Clean the inside of bucket as needed. (Fig.2)

After cleaning, replace the bucket cover and slide the bucket into the unit. (Fig.3) Check the float switch to make sure it is not obstructed. Proper position of the bucket

and the float switch is required for the dehumidifier to turn on.

Fig.2

Float Switch

Fig.3

10 11