FAN Speed Indicator, Delay Start | Kenmore 407.52301 specs

(7)

(9)

(lp) (1.1) (12) (1,3)

(4)

(5)

(2)

(3)

(1)

(6)

POWER ONtOFF (1)

Once the unit is plugged in, the POWER INDI-

CATOR (t0) will light up. Pressing the Power button once will turn the unit ON and illuminate

the digital display (9). The display will show the humidity level of the room in 5% increments down to 25%. Pressing the Power button again will turn the display OFF and the unit will cease operating.

HUMIDITY LEVEL (2/3)

The humidity level can be set in 5% increments

in a range from 35% to 80%. The humidity setting is shown in the digital display. When the

humidity level of the room reaches the set level, the unit will stop dehumidifying.

To set the unit to continuous operation, press the down arrow button until the display shows 35%. Press again and the display will show CO. The Continuous indicator (13) will light up on the control panel. To leave continuous op- eration, press the up arrow button.

To check the current humidity setting, press the up or down arrow button. The display will show and set 5% above or below the current setting.

FAN SPEED (5)

Press Fan Speed to togglebetween Low, Med,

and High fan speeds. Speed wiiJbeshownin

FAN SPEED INDICATOR (8)

BUCKET FULL INDICATOR (11)

When the collection bucket is full, the BUCKET

FULL indicator (11) will light up and you will hear an audible alarm. The audible alarm will

last up to ten seconds The dehumidifier will not run until the bucket is removed, emptied and replaced.

DELAY START (4)

Unit can be programmed to turnon at a desired delay time bypressing the Timer (4) key. When the unit is poweredOFF, pressthe timer keyoncefor 2-hourdelaystart.The 2 Hrs (7) timer indicatorwill lightupwhen the timerkey ispressed.Pressthe timerkey once morefor a 4-hourdelay start.The 4 Hrs (7) timer indicator

will now lightup. Pressthe timerkey a third timeto clear the timersetting.No timer indica-

tors willlightupwhen the timersettingis cleared.

AUTO SHUT-OFF (4)

Unit can be programmed to turn off at a desired time by pressing the Timer (4) key. When the unit is powered ON, press the timer key once for 2-hour automatic shut-off. The 2 Hrs (7) timer indicator will light up when the timer key is pressed. Press the timer key once more for a 4-hour automatic shut-off. The 4 Hrs (7) timer indicator will now light up. Press the timer key a third time to clear the timer setting. No timer

indicators will light up when the timer setting is cleared.

FILTER RESET (12)

The FILTER RESET indicator (12) will light up when the filter needs cleaning, Remove the filter and clean accordingly. Replace the filter when finished and press and hold the FILTER

(6)key up to 5 seconds to reset the filter indi- cator.