Removing Collected Water

1.Emptying the Bucket:

a.When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate.

O _ONT_NUOUS

_u 0 BUCKET FULL

LOW 0 b_

PBWE_

b.Do not move the unit at this point otherwise water may spill on the floor.

c.Press sides of bucket gently to unclip the bucket from the unit.

d.Remove the bucket as shown in the photographs below and empty the bucket.

e.Replace the empty bucket back into the unit and once seated correctly the unit will start up again.

f.You should hear a click when the bucket is in the correct position

If the bucket full light does not extinguish, check that the float is correctly snapped

in place as indicated by the photo.