ACCESS PANEL
FILTER ACCESS
PANEL*
*For accessory ®lter rack.
Fig. 5 Ð Filter Access Panel Ð Vertical Supply Shown
Electrical Controls and Wiring Ð Electrical con- trols are difficult to check without proper instrumentation; therefore, if there are any discrepancies in the operating cycle, contact your dealer and request service.
Refrigerant Circuit Ð The refrigerant circuit is diffi- cult to check for leaks without the proper equipment; there- fore, if inadequate cooling is suspected, contact your local dealer for service.
Combustion Area and Vent System Ð The com- bustion area and vent system should be inspected visually before each heating season. The normal accumulation of dirt, soot, rust, and scale can result in loss of efficiency and im- proper performance if allowed to build up.
If your unit makes an especially loud noise when the main burners are ignited, shut down the heating section and call your dealer.
Proceed as follows to inspect the combustion area and power- venting system of your unit.
1.Turn off electrical power and gas supply to your unit.
2.Remove burner access panel. (See Fig. 1.)
3.Using a ¯ashlight, carefully inspect the burner areas for dirt, soot, rust, or scale. See Fig. 2.
If dirt, soot, rust, or scale accumulations are found, call your dealer and do not operate your heating sec- tion.
4.When you have completed your inspection, follow the
5.Observe unit heating operation.
Components in heat section may be hot after unit has been started up. When observing ¯ame, be care- ful not to get close to or touch heating components or serious personal injury may result.
Watch the burner ¯ame to see if it is bright blue. If you observe a suspected malfunction or if the burner ¯ames are not bright blue, call your dealer.
6. Replace burner access panel.
Unit Panels Ð After performing any maintenance or serv- ice on the unit, be sure all panels are fastened securely in place to prevent rain from entering unit cabinet and to pre- vent disruption of the correct unit air¯ow pattern.
REGULAR DEALER MAINTENANCE
In addition to the type of routine maintenance you might be willing to perform, your unit should be inspected regu- larly by a properly trained service technician. An inspection (preferably each year, but at least every other year) should include the following:
1.Inspection of all ¯ue product passages Ð including the burners, heat exchanger, and ¯ue collector box.
2.Inspection of all combustion- and
3.Close inspection of all gas pipes leading to and inside of your unit.
4.Inspection and, if required, cleaning of the condenser and evaporator coils.
5.Inspection and, if required, cleaning of the evaporator drain pan.
6.Inspection and cleaning of blower wheel housing and motor.
7.Inspection of all
8.Inspection of the unit base to ensure that no cracks, gaps, etc., exist which may cause a hazardous condition.
9.Inspection of the unit casing for signs of deterioration.
10.Inspection of all electrical wiring and components to as- sure proper connection.
11.Inspection for leaks in the refrigerant circuit. Pressure- check to determine appropriate refrigerant charge.
12.Inspection of compressor oil level.
13.Operational check of the unit to determine working con- ditions. Repair or adjustment should be made at this time.
Your servicing dealer may offer an economical service con- tract that covers seasonal inspections. Ask for further details.
Complete service instructions can be found in the unit Installation,
WARRANTIES
Units 48GS and GX have warranties located at the back of this book. Be sure to read the warranty carefully to de- termine the coverage for your unit.
6