| Installation and Operating Instructions | ||
Dimplex | 08/18724/2 | Issue 2 | |
Models : WFC 3NB and WFC 3NS |
|
| |
Dimensions |
| 575mm | 120mm |
Model(s) | Specification |
|
|
WFC 3NB | 3kW, Switch, Thermostat & Neon - Black |
|
|
WFC 3NS | 3kW, Switch, Thermostat & Neon - Silver | 350mm |
|
| Fig. 1 | 350mm min | |
THESEINSTRUCTIONSSHOULDBEBEREADCAREFULLYANDANDRETAINEDFORFORFUTUREREFERENCE..
IMPORTANT SAFETY ADVICE
WARNING – THIS APPLIANCE MUST NOT BE USED IN A BATHROOM.
WARNING – DO NOT USE THIS HEATER IN THE IMMEDIATE SURROUNDINGS OF A BATH, A SHOWER OR A SWIMMING POOL.
WARNING – THIS HEATER MUST NOT BE LOCATED IMMEDIATELY BELOW A FIXED SOCKET OUTLET.
DO NOT USE THE HEATER UNTIL IT IS WALL MOUNTED CORRECTLY.
The heater carries a warning 'Do Not Cover' to alert the user to the risk of overheating that exists if the heater is accidentally covered.
NEVER cover or obstruct in any way the air inlet slots at the front of the heater or the heat outlet slots in the base of the heater.
Keep combustible materials such as drapes and other furnishings clear from the front of the heater. Do not use heater to dry your laundry.
This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilities prevent them from using it safely. Children should be supervised to ensure that they do not play with the appliance.
If young children, the aged, or infirm are likely to be left in the vicinity of the heater, we advise that adequate precautions should be taken. We recommend that a guard be fitted to ensure contact with the heater is avoided and objects cannot be inserted into the product.
WARNING: In order to avoid a hazard due to inadvertent resetting of the thermal
For further information, please contact our guard supplier direct on Tel. No. 01603 667957, or in the case of difficulty or for further advice contact the Customer Helpline.
Installation
Before undertaking installation work, ensure the electricity supply is disconnected from any relevant fixed wiring.
Supply cable is not provided with this appliance, and a competent electrician should therefore install it.
The appliance must be fitted horizontally with the cable or conduit entry at bottom right. It should be mounted such that the underside is at least 350mm above the floor and the top of the heater is 150mm below any overhanging shelf or obstruction.
This heater must be used on an A.C.~ supply only and the voltage marked on the heater must correspond to the supply voltage.
To comply with the I.E.E. Wiring Regulations, the appliance must be earthed; the supply circuit must be adequate for the input of the appliance, and the circuit protected by a suitable 13A fuse. A suitable termination to the fixed wiring of the premises must be provided adjacent to the final position of the appliance. In this instance, such a termination can be a double- pole switch with a contact separation of at least 3mm in all poles.
The heater must not be located immediately below a fixed
Electrical
WARNING : THIS APPLIANCE MUST BE EARTHED.
After ensuring the electricity supply is not live, electrical connections can be made, either to an adjacent
If the latter: Connect Green and Yellow wire to plug terminal
marked E or 
Green or Green and Yellow. Connect Blue wire to plug terminal marked N or Black. Connect Brown wire to plug terminal marked L or Red.
Refit cover, first hooking top over the back of the unit and then securing the bottom by refitting the two screws under the bottom edge. The appliance is now ready for use and the electricity supply can be reinstated.