Aprilaire model 800 specifications Start-Up Procedure, Sequence of Operation, Operating Modes

Page 11

Start-Up Procedure

See “Sequence of Operation” and Operating Modes” for explanation of humidifier operation..

1.Once the supply water, drain, steam hose and electrical power and control wiring connections are complete, reattach the side panel and the front panel..

2.Open the saddle valve allowing water to flow to the humidifier.. Check for leaks..

3.Close the main power switch..

4.Turn humidifier on by pressing “On/Off” button on front panel.. The green “On/Off” light will turn on..

5.Make sure the HVAC blower is operating (or the ADHC is set to call the blower) and adjust the ADHC dial up to initiate a call for humidity.. Note: The ADHC can be placed into “TEST” mode to force a call for humidity but this will only last for one minute..

The “Fill” light will be illuminated indicating that the fill valve is open and the canister is filling.. The “Steam” light will also turn on indicating that the humidifier is receiving a call for humidity..

6.Verify that steam light turns on, then turn unit off.. “On/Off” light will turn off and “Drain” light will flash green.. Water will drain from humidifier..

7.Once light stops flashing, sequence is complete and unit can be turned on again for normal operation..

8.Set ADHC to appropriate level..

Note: If the conductivity of the water is not within the 125 to 1,250 uS/cm range, the humidifier may run through a series of drain and fill cycles to condition the water into that range.. This process may take up to 96 hours.. See explanation of display panel, Table 4, and operating modes..

Sequence of Operation

When the Automatic Digital Humidifier Control (ADHC) detects RH below the set point, and provided the humidifier is turned on and the HVAC system blower is operating, the internal controller in the humidifier energizes the electrodes and measures the current flowing through the water between them.. The controller adjusts water level in the canister via a fill valve and a drain valve to maintain current at 11..5 amps ± 1..2 amps.. The operating water level in the canister depends on the mineral content of the water which determines conductivity..

The ADHC has the ability to turn on the HVAC system blower if the homeowner or installer chooses to utilize that feature.. See ADHC installation manual..

Operating Modes

When the humidifier is powered and turned on, the “On/Off” light is illuminated green.. Any time the fill valve is activated, the “Fill” light illuminates green..

Any time the drain valve is activated, the “Drain” light illuminates green..

During initial start up with a new canister, the humidifier may run through a series of fill/drain cycles until the conductivity of the water is in a range that allows normal operation.. During this time, the “Steam” light illuminates green.. If the humidifier cannot produce steam at the rated level after trying for 48 hours, the “Steam” light illuminates yellow.. The humidifier continues to attempt to produce steam at the rated level for another 48 hours in this mode.. If the humidifier cannot produce steam at the rated level in a total of 96 hours, the “Service” light will flash red..

The conductivity of naturally soft water, hard water, and softened water changes as the water heats up, but the controller adjusts the water level to maintain a nominal current of 11..5 amps ± 1..2 amps between the electrodes.. Over the life of the canister, minerals that build up on the electrodes will reduce their effective surface area and affect the resistance between them.. The operating water level will increase with use until it reaches the high water level probe.. At that point, the “Service” light will flash red indicating that the canister needs to be replaced..

When the humidifier is operating, the “Steam” light on the front illuminates green.. If the internal controller attempts to make steam but the water does not contain enough minerals to be conductive, the water level in the tank will reach the high level point and the “Steam” light will illuminate yellow..

Any time power is disconnected or humidifier is turned off, the internal timer for start-up and drain cycles is reset..

If the humidifier has operated 168 hours without a drain cycle, the drain valve will open and drain the canister.. Normal operation will continue..

If the humidifier is operating and a power failure occurs, once power is restored, the “On/Off” light will flash green for one minute, then the humidifier will turn on..

End of Season/Period of Inactivity Shut-down

If the humidifier does not receive a call to operate in 72 hours, the controller drains the canister.. The humidifier will resume normal operation when a call for humidity is made..

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Table of Contents Installation & Maintenance InstructionsO..D.. supply water tubing Safety CautionsMain power disconnect switch Materials Furnished Not FurnishedHumidifier unit Specifications & DimensionsSpecifications Maximum Principles of OperationElectrical Knockouts Mounting PlateTo first opening Dia600 fpm 1200 fpm 1800 fpm 300 fpm Choosing a location Dispersion TubeDuct Location 300 fpmSteam Humidifier Capacity in Gallons/Day Steam Hose Volts Installation InstructionsElevation Distance from Humidifier to Dispersion TubeAdhc Automatic Digital humidifier Control Model Installation Instructions16 for 30 for Electrical Service Access Mount Humidifier Install Steam Dispersion TubeInstall Steam Hose Prepare Humidifier for MountingDo not loop power wiring.. Do not use aluminum wire Automatic Digital Control and Control WiringElectrical Power Wiring & SHUT-OFF Switch Wiring InstructionsInstallations Remove N-L2 Jumper End of Season/Period of Inactivity Shut-down Start-Up ProcedureSequence of Operation Operating ModesLight Display PanelDisplay Panel To Replace the Canister MaintenanceTo Service the Fill Valve Malfunctioning fill valve Troubleshooting GuideTroubleshooting Guide No power to humidifierMalfunctioning control Problem Possible cause ActionDrain valve, or plugged Manual Humidistat & Blower Activation relay Item No. Part No. DescriptionDe N PiècPièce Claquement Un GuidAnna Robinet leProblème Anna GuidEtien EntrRép aPoreurle CartuchoAffd Pichnneag e VoyantLeau de IcôneDém Darre ag e Céduro Fond eTion ASéquenAllation Câblage de DiagrammeOncdutrôle âblac Con Âblac d e g eDarr êt Ni rrupte Ure éctrile Qeu e Lald e TationgeMon tagpeourle Humidie TationVentilateur bloc le avec Allation DégagementsUmidiH Tablea Isolé TuyauVapeur à boyau Volts Du Longueur’HR % 45 de réglage DHR % 30 de réglage AllationCm 12,7 Cm 10,2 Cm 7,6 Min Cm 17,8 Cm 15,2 Cm 17,8 Cm 15,2 Cm 7,6 Min Cm 33,0 Cm 27,9Se tpéciS CtionnePri DimTpéciS FondUAtion MISPréc Fo Non Ur nis Matéri foauxSécurité de Précautions Dinstallation DirectivesTièr Matériaux de isteL

model 800 specifications

The Aprilaire Model 800 is a powerful and highly efficient whole-house steam humidifier designed to provide optimal humidity levels throughout your home. This innovative product is particularly beneficial for homeowners seeking to maintain comfortable living conditions while enhancing air quality.

One of the standout features of the Model 800 is its capacity to generate up to 34 gallons of moisture per day. This remarkable output makes it suitable for larger homes or those with multiple rooms that require humidity control. It can effectively humidify living spaces ranging from 3,000 to 6,200 square feet, ensuring that every corner of the house is adequately served.

The Model 800 employs advanced steam technology, which allows it to generate steam that is then distributed throughout the home’s heating system. This method ensures consistent and efficient moisture distribution, unlike traditional humidifiers that may struggle to cover larger areas. The steam created is clean and free of significant mineral content, reducing the risk of “white dust” that can accumulate when using some other types of humidifiers.

Another key characteristic of the Model 800 is its user-friendly interface. The unit features a built-in humidistat that continually monitors and adjusts humidity levels according to the specific requirements of your environment. Water usage is optimized and can be tailored to your home’s needs for enhanced efficiency.

Installation flexibility is a notable advantage of the Model 800 as well. It can be connected to various types of heating systems, including forced air and hydronic setups. This versatility makes it a great choice for different residential applications.

Furthermore, Aprilaire has incorporated low maintenance design considerations into the Model 800. The steam unit is designed with a replaceable canister that helps simplify routine care. Homeowners can enjoy the benefits of this humidifier without the burden of frequent upkeep.

Overall, the Aprilaire Model 800 stands out in the market for its performance, innovative technology, and user-friendly features. It is a reliable solution for anyone looking to enhance indoor air quality and comfort throughout their home. Whether in winter when dry air is prevalent or in any other season, the Model 800 ensures a comfortable and healthy living environment.
Top Page Image Contents