Bionaire CP2550 manual Filling the Water Tank, Using the Medication CUP

Figure 4

To monitor the actual humidity level in a room, we recommend the use of a humidity meter such as the BIONAIRE® Digital Humidity and Temperature Monitor BT400 or BT254, which can be purchased by calling our Consumer Service Dept.

at 1-800-253-2764.

FILLING THE WATER TANK

Figure 3

When the water tank is empty, the “EMPTY” light will illuminate and no moist air will be produced until the water tank is refilled.

1.Switch the humidifier off.

2.Lift out the tank and carry it to a water tap.

3.Twist the tank cap counter-clockwise approximately 1/4 turn. The cap should now lift away.

4.Fill the tank with cool tap water.

5.Replace the tank cap, making sure the large O-ring is in its correct position. Occasionally apply a thin coat of petroleum jelly to the O-ring to ensure easy removal of the tank cap.

6.Carry the full tank with both hands and carefully replace it into your humidifier. Wait a few minutes for the tray to refill.

7.Turn the unit back on.

8.Press the “RESTART” button. The “EMPTY” light should extinguish and moist air will be emitted within a few minutes.

Note: At "HI" setting, the tank may last up to 28 hours. At "LO" setting, a full tank may last up to 56 hours.

WARNING: All cleaning agents must be thoroughly rinsed away after use and before the unit is returned to service.

USING THE MEDICATION CUP

A medicated vapor can be distributed with the "mist" output.

To add medication to the vapor:

1. Switch humidifier off and allow removable cover - outlet grill to cool down.

2.Lift the removable cover off (Figure 4) to access the medication cup.

3.Remove the medication cup from the misting chamber.

4.Carefully add liquid medication; do not fill cup more than half full.

5.Carefully place the medication cup

5