Sirius II 2, 4 & 8 ZONE FIRE ALARM PANEL
USER GUIDE
1.GENERAL
The Sirius II fire alarm panel comes in 2, 4 and 8 zone versions. The panel is mains powered and also has two standby batteries (12 V, 7 Ah). The front panel features an LCD display, a zone window, status windows and user controls.
2.PANEL DISPLAY
The zone windows have an alarm light (red) and a fault light (yellow) next to each zone. The panel status windows have a single light next to each category. All lights are coloured yellow except the POWER ON light (green) and the ALARM light (red). The lower row contains the control switches used for programming, test and maintenance.
Status Windows | Zone Windows |
Control Switches
3.OPERATION
There are two levels of user access to the panel’s controls. Access Level 1 is the normal operating condition, where with no zones disabled, the green POWER ON light is on and all other lights are off. The TEST button, which is used to test all of the lights in the panel display, is operative. All other controls are inoperative and are only available in Access Level 2. A pass code is required to enter Access Level 2.
To enter Access Level 2, press the ACCESS button and, using the UP, DOWN and ENTER buttons, enter the pass code 7179. The yellow PANEL ACCESS light comes on. To revert to Access Level 1, press the ACCESS button twice.
Note: The panel can be configured for the internal buzzer to be disabled. All references to it in this User Guide assume that it is enabled. If you are unsure about whether the internal buzzer is enabled or not, contact your service provider.
TM0109 | Page 1 of 4 | Rev 1 |