5.0Handgun Displays and Controls:
| 0 |
| 2 |
| 10 |
0 |
|
O |
|
F | F |
|
30 | 40 |
| |
% | Al |
|
50 | 60 | 70 |
| ||
|
| |
arm |
|
80
90
The following controls are found on the hand unit:
5.1Analogue gauge: displays the response to leaks in %, rather than an absolute value (displayed on the
5.2Handgun Six LEDs indicate status.
COLOUR | No | DESCRIPTION |
|
|
|
Green | 1 | READY TO MEASURE. Normal operation. If ON, you may |
|
| confidently measure. This is OFF whenever the instrument is |
|
| in standby or programming mode, error condition, or the |
|
| actual reading is above 20% of the alarm level. |
Red | 2 | NOT READY. This light is on whenever the instrument is in |
|
| the programming mode, or an error condition exists. It |
|
| flashes during standby mode. |
Green | 3 | SPECIAL. Desensitise functions, flashes when one of them |
|
| is active. |
|
|
|
Yellow | 4 | SIGNAL. Switches on whenever a reading above 20% alarm |
|
| level was taken. Reset by STORE or CLEAR key. |
|
|
|
Red | 5 | ALARM. This light is on as long as a reading equal to or |
|
| above the alarm level is taken. |
|
|
|
Yellow | 6 | MESSAGE. Prompts the operator to read a message that is |
|
| present on the LCD screen. |
|
|
|
Page 4