Model Ei151TLR Ionisation

Technical Specification

Sensor	Ionisation
Sensitivity:	Complies with BS 5446 Part 1:
	2000
Source:	Americium 241
Button Test:	Simulates the effect of smoke and
	checks electronics and horn.
Supply Voltage:	230V AC
Battery back-up:	Rechargeable lithium cells
Power-On Indicator:	Continuous green LED
Alarm:	Electronic Piezoelectric horn
	in unit
Alarm Sound Output: 85dB (minimum) at 3m
Alarm Status:	Red LED flashes every second on
	unit sensing fire

Temperature Range:	0° to 40°C
Humidity Range:	15% to 95% Relative Humidity
Remote control:	Ei152, Ei159 or MCP400
Interconnect:	Up to 12 interconnected
	Ei150/151TL/151TLR/154TL/155/1
	56TLH/156TLR smoke or heat
	alarms, along with an EI158 relay
	base
Fixing:	Screw fixings supplied
Plastic material:	UL94VO flame retardant
Dimensions:	140mm x 120mm x 46mm
Weight:	227g
Warranty:	5 year (limited) warranty
Approvals:	Kitemarked to BS EN 14604:2005,
	CE Approved

Specifications are subject to change

Installation & Placement

Wiring for Interconnected Alarms

Be very careful about correctly wiring the alarms as mixing Live and Neutral will blow/damage interconnected alarms.

Alarms should be placed in accordance with the general guidelines shown in the diagram above. These recommendations are based on the problem of areas of “dead air” close to corners of rooms and apexes of ceilings, which could result in the prevention of smoke reaching the smoke detector

Please consult instruction booklet for specific installation details

Important Precaution:

Do not install the actual smoke/heat alarm itself in new or renovated buildings until all work is completed (including floor coverings) and the building has been fully cleaned. The wiring can be installed when appropriate. (Excessive dust and debris from building work can contaminate the smoke chamber and cause problems, and it will also invalidate the guarantee). If it must be installed, cover it completely, particularly around the edges, with a dust cover (eg. a plastic bag), until all cleaning is finished.. Connect wires to the unit as in wiring diagram. All wiring must comply with local codes.

Shannon Free Zone, Shannon, Co. Clare, Ireland.

Ph.+353 61 471277 Fx.+353 61 471053

Email. eielectronics@eiltd.ie

Web: www.eielectronics.com

E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior not ice.

Ei151TLR DataSht RevB