Ei Electronics manual Model Ei175 Ionisation, Technical Specification, Placement Information

Page 2

Model Ei175 Ionisation

Technical Specification

Sensor

Ionisation

Power-On Indicator:

Continuous green LED

Sensitivity:

Complies with BS 5446 Part 1:

Alarm:

Xenon tube strobe (1Hz)

 

2000

 

 

Source:

Americium 241

Airspeed:Essentially immune to the effect of airspeed.

Button Test:Tests strobe, vibration pad and

panel

Temperature Range:

0 to 40°C

Humidity Range:

0% to 90% Relative Humidity

Interconnect:

Up to 12 interconnected

 

Ei100C/105C/103C smoke/heat

 

alarms

Fault Monitor:

Open/short circuit

Supply Voltage: 230V AC standby 8mA, alarm

40mA

Battery back up: Sealed Rechargeable lead acid

battery

Fixing:

Screw fixings supplied

Plastic material: UL94VO flame retardant

Dimensions: 5 year (limited) warranty

Approvals:BS 415:1990 electrical safety

Specifications are subject to change

Auxiliary socket: Provides 12V/200mA in alarm

Placement Information

Alarms should be placed in accordance with the general guidelines shown in the diagram above. These recommendations are based on the problem of areas of “dead air” close to corners of rooms and apexes of ceilings, which could result in the prevention of smoke reaching the smoke detector

Important Precaution:

Do not install the actual smoke/heat alarm itself in new or renovated buildings until all work is completed (including floor coverings) and the building has been fully cleaned. The wiring can be installed when appropriate. (Excessive dust and debris from building work can contaminate the smoke chamber and cause problems, and it will also invalidate the guarantee). If it must be installed, cover it completely, particularly around the edges, with a dust cover (eg. a plastic bag), until all cleaning is finished.. Connect wires to the unit as in wiring diagram. All wiring must comply with local codes.

Shannon Free Zone, Shannon, Co. Clare, Ireland.

Ph.+353 61 471277 Fx.+353 61 471053

Email. eielectronics@eiltd.ie

Web: www.eielectronics.com

E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior notice.

Ei175 DataSht RevA

Image 2
Contents Model Ei 175 Ionisation Product Description OperationModel Ei175 Ionisation Technical SpecificationPlacement Information