CASSETTE OPERATION (CONTINUED)
MAKING A TAPE RECORDING
The tape recorder in this system allows you to make direct recordings from the radio or CD player to a blank cassette in the tape compartment. An automatic recording volume level control (ALC) circuit will automatically control the volume level of your recordings to prevent distortion. You may change the settings of the volume or the Bass Boost during a tape recording, as these controls have no effect on the material being recorded onto the tape.
To make a tape recording, proceed as follows:
1 | Open Surface Side |
| Full Reel on Right |
2 |
2 |
1 |
3 |
Open the Cassette Door and insert a good quality blank cassette tape into the slots on the door, with the open end facing up and the full reel on the right side. Close the Cassette Door.
Press the POWER button 1 to the in position and slide the Function switch 2 to select the function you wish to record, either CD, AM or FM, and operate that function according to its own instructions.
When you are ready to begin recording, press the RECORD (Q) button. The PLAY (Ã) button will also engage. The tape will begin moving and all of the material from your selected source will be recorded on the tape.
4 |
5 |
6 |
|
| 3 |
2 | 4 |
To avoid recording unwanted material, such as radio commercials, use the PAUSE (p) button to stop the recording temporarily. Release the PAUSE (p) button to begin recording again.
When you are finished recording, press the STOP/EJECT (■ ) button to stop the tape.
If you wish to listen to your recording immediately, press the cassette REWIND (¨¨) button 1 until the tape rewinds to the beginning, then press the STOP/EJECT (■) button 2. Slide the Function switch 3 to the TAPE/POWER OFF position, then press the PLAY (Ã) button 4 to begin playback.
11