Baxi Potterton 105E manual Clearances and Check List, Clearances around the Boiler

5mm Min 450mm

Fig. 23

450mm Min

For Servicing

Purposes

5mm

In Operation

Fig. 24

5mm Min

200mm Min

780mm

200mm Min

4.0Clearances and Check List

4.1Clearances around the Boiler

(Figs. 23 & 24)

1.The minimum clear spaces needed around the boiler measured from the casing are as follows:

Top	-	200mm
Bottom	-	200mm
Both sides	-	5mm
Front	-	5mm	(In Operation)

-450mm (For Servicing)

2.These areas must not be obstructed in any way. Blocking the clearance spaces may result in the boiler overheating and damage may occur.

3.The gas burning compartment of your boiler is completely sealed from the room in which it is fitted. Products from the combustion of gas are vented to the outside through the flue terminal which must be kept free from obstruction as this would interfere with the correct operation of the boiler.

4.The boiler may be installed in a cupboard if these minimum clearances are kept. The compartment should be large enough to house the boiler and ancillary equipment only.

5.IT SHOULD NOT BE USED AS A STORAGE CUPBOARD.

4.2Check List

1.If a fault develops, or is suspected, call your Service Engineer as soon as possible.

2.Go through the following check list before you make contact.

a)Is the electricity supply on ?

b)Is the selector switch on (giving a green

“Power ON” neon) and set for both Central Heating and Domestic Hot Water ?

c)Is the red “Flame Failure” neon lit ? Turn the On/Off/Reset selector fully anti- clockwise.

d)Is the gas supply on ?

e)Is the mains water supply turned on ?

f)Is the system pressure correct ?

g)Are the boiler temperature controls set high enough ?

h)Is the time clock (if fitted) calling for central heating ?

i)Is the room thermostat (if fitted) set high enough ?

j)Are the radiator valves open ?

9