Sears 42-34714 installation instructions INSTALLATiON iNSTRUCTiONS, To Assemble Faucet, Wet

iNSTALLATiON iNSTRUCTiONS

Stock No. 42=34713, 42=34714, 42=34715 Faucet

TO ASSEMBLE FAUCET:

1. If not already assembled, install the escutcheon, rubber washer, spacer, flat washer and hex nut onto the threaded faucet stud.

2. Turn the tubing adapter onto the stud and hand tighten, then wrench 1/4 turn only. BE CAREFUL NOT TO CROSS THREAD.

3. CONNECT TUBING TO FAUCET AS FOLLOWS.

Note: For ease of tubing attachment, feed the tubing through the mounting hole and attach to faucet above the counter.

a. Take the separate length of 3/8" black tubing put an end through the hole in the rubber

washer. Slide the end onto the larger barb fitting on the bottom of the faucet.

Note: To soften end of tubing, hold under hot water.

b. Route 1/4" red tubing from RO up through the sink hole and slide end onto the smaller barb

fitting (heat end if needed) on the faucet.

c. Route 3/8" blue tubing from RO up through the sink hole and connect to the push-in tubing adapter fitting on the bottom of the faucet. Be sure it is held firmly in the adapter fitting. See your owners manual for tubing connection instructions.

4. Lower the faucet into the sink or countertop

hole.

Insert

Spout __.._ _ Remove

Tubing Piece T

Plumber's

ASSEMBLED iN

MOUNTING HOLE

Rubber

Washer

Steel

Washer

Hex Nut

Faucet &

Spout

Tubing Barb

Fittings

Escutcheon

Rubber

Steel

_'/Washer

I.- Spacer

Flat

(_ _'_"_ Washer

_'_-"---- Hex Nut

5. On	the	underside of			the	sink	or	countertop,
insert	the	large	steel		washer		between		the
mounting		hole and	the	spacer		on	the	faucet	stud
(see assembled view). Then, turn the hex nut up
to the spacer and tighten. Tighten the hex nut so
the faucet		cannot	move,		but	do	not	overtighten
and break		the faucet.
6. Wet	the	o-ring seals on			the	faucet spout. Then,
remove	and discard		the	short		piece	of	tubing	from
the faucet body and insert the spout in its place.

			/	Adapter
				Tubing
		_	_	1/4" Red
,,	/-/	/l	/	/"_--Tubing from
3/8 Black Tubing..........-._/ /		\\//		Drain Point
to Drain	Poinl/8, 'Blu/e_//_.I.!!NG			FROM
	Tubing		RO SYSTEM

Installation Questions? Call 1=800=426=9345

7254715 (Rev. B 9/19/07)