Sears 661.62453 Final Assembly and Adjustment, PUT Float Valve in Cooler, Oil, Adjust Water Level

iNSTALLATiON

FINAL ASSEMBLY AND ADJUSTMENT

PUT FLOAT VALVE IN COOLER

Put the float valve through the spout hole and cabinet hole Tighten the ring nut Be sure the float moves straight up and down. TURN THE FLOAT UNTIL A NARROW SIDE IS UP. Snap the Sp(ash Guard Cover into the Water Spout as shown The Water Spout and Splash Guard Cover are provided

to prevent water from "spurting "and splashing out- side the Water Reservoir,

CONNECT WATER LiNE

For outdoor Hook Up, use #62527 Copper Hook Up Kit or #62528 Plastic Hook Up Kit Both kits contain all necessary fittings to connect water to cooler For indoor kit use copper tubing and #62522 self pierc- ing saddle valve.

PUT IN OVERFLOW PIPE (Fig. 11)

1 Push the drain fitting through the washer and water tray hole Tighten the ring nut. Screw the overflow pipe into the drain fitting Repeat for the second tray.

NOTE: INSTALL DRAIN FITTING INVERTED tF COOLER IS MOUNTED ON A PAD. CUT OFF THE OVERFLOW PIPETOP FLUSH WITH THE HEXAGONAL RING.

Put in the float valve side tray first The cros- sover tube and grommet MUST be on the float valve side (Fig 12).

Push the crossover tube into the grommet° Use

soap or detergent as a lubricant DO NOT USE

OIL,,

4 Put the second water tray in place. Push the crossover tube into the grommeL

ADJUST WATER LEVEL

5_ Turn on the water. Check the water level when the valve shuts off, If the water'level is above the tray water leve) mark bend the float rod down If the level is too low, bend the rod up,,

GROMMETS AND ALL CONNECTIONS

I NOTE: CHECK THE CROSSOVER PIPE FOR LEAKS.

PUT LOUVERS ON COOLER

Seepage 11

COMPRESSION

NUT

FLOAT

VALVE

NUT

P R EpSuS!ON _	FERRULE
%
ADAPTER

OVERFLOW

PIPE

DRAIN FITTING

WASHER

WATER LEVEL

MARK

GROMMET

CROSSOVER

PiPE FLOAT

VALVE

8