Cord Retractor

For cord storage, this vac includes a cord retractor to remove the cord from sight. Due to the height of the cord exit, it is spe- cifically designed to retract slowly.

Operation

1.Locate the plug end recessed in the left side of the motor cover.

2.Place one hand on the motor cover and

use the other hand to pull the cord from the vac.

3.Pull out cord to desired length. The cord will lock in place when cord is released, during the clicking sound.

NOTE: Cord will not lock in place when it is fully extended. Let about 12 inches

retract, then pull cord while listening for the clicking sound. Release cord and it should lock into place.

IMPORTANT: To avoid damaging vac or cord, be sure the full cord is available. Do not pull on vac and hose to extend the cord to longer lengths.

4.Proceed to vacuum.

5.When area is clean, turn off the vac. Unplug the cord at the receptacle.

6.With plug in hand, walk to vac and gen- tly pull on cord at the exit to release the lock.

7.As cord retracts, hold onto plug and fol- low it into the motor to keep water and debris off plug and cord.

NOTE: In cold weather the cord becomes stiffer. This increased stiffness will cause slowdown of the retraction rate. For best retraction of the cord, store cord immedi- ately after vacuuming is complete.