Memorex MP3228 manual Wall or Ceiling Mounting

SAFETY INSTRUCTIONS (CONTINUED)

15.OVERLOADING

Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

16.OBJECT AND LIQUID ENTRY

Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid on the product.

17.OUTDOOR ANTENNA GROUNDING

If an outside antenna is connect-
ed to the product, be sure the	ANTENNA
antenna system is grounded so
	LEAD IN
	WIRE
as to provide some protection

against voltage surges and built-		GROUND
up static charges. Section 810 of		CLAMP
the National Electric Code,		ANTENNA
ANSI/NFPA 70, provides informa-		DISCHARGE UNIT
		(NEC SECTION 810-20)
tion with respect to proper
grounding of the mast and sup-	ELECTRIC
	SERVICE	GROUNDING CONDUCTORS
porting structure, grounding of the
	EQUIPMENT	(NEC SECTION 810-21)
lead-in wire to an antenna dis-		GROUND CLAMPS
charge product, size of grounding		POWER SERVICE GROUNDING
		ELECTRODE SYSTEM

conductors, location of antenna	NEC - NATIONAL ELECTRICAL CODE	(NEC ART 250, PART H)
	S2898A
discharge product, connection to
	EXAMPLE OF ANTENNA GROUNDING AS PER
grounding electrodes and require-
	NATIONAL ELECTRICAL CODE
ments for grounding electrode.

18.SERVICING

Do not attempt to service this product yourself as opening or removing covers may expose you to danger- ous voltage or other hazards. Refer all servicing to qualified service personnel.

19.REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitu- tions may result in fire, electric shock or other hazards.

20.SAFETY CHECK

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

21.WALL OR CEILING MOUNTING

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

22.DAMAGE REQUIRING SERVICE

Unplug the product from the wall outlet and refer servicing to qualified service personnel under the follow- ing conditions:

a.When the power-supply cord or plug is damaged.

b.If liquid has been spilled or objects have fallen into the product.

c.If the product has been exposed to rain or water.

d.If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e.If the product has been dropped or the cabinet has been damaged.

f.When the product exhibits a distinct change in performance–this indicates a need for service.

23.HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) that produce heat.

24.NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be con- nected to the grounding system of the building, as close to the point of cable entry as practical.

5