Honeywell RTH110B user manual Manual abstract

Manual abstract:

By default, the setpoint is 70°F (21°C). 2.3.4 3-wire Cooling 2.6 Completing the Installation Cool relay Fan relay 2.3.5 4-wire Heating and Cooling Once the

baseplate and the batteries are installed, mount the thermostat on the baseplate. Heat relay Cool relay Fan relay Secure the thermostat using the locking

screw and install the faceplate. Apply power back to the system. 2.

3.65-wire Heating and Cooling 3. Basic Functions 3.1 System Operating Mode Use the selector switch to place the system in Heating mode (HEAT) or Cooling mode (COOL), or to turn the system off. Fan relay Heat relay Cool relay Note: When you place the thermostat in Cooling mode, you might need to

wait up to five minutes before cooling can start.

This is a safety feature for the compressor. will flash on the screen until cooling can start again. RTH110B 69-1799 2/6/05 2/3 3.2 Fan Operating Mode Use the selector switch to set the fan to automatic mode (AUTO) or continuous mode (ON). Note: This switch is not used if you have a 2-wire installation as the fan is not connected to the thermostat.

·· AUTO If you have an electric furnace (see section 2.4), the fan works only when heating or cooling is activated. If you have a gas or fuel oil furnace (see section 2.4), the fan works as follows: · When the thermostat is placed in cool mode, the fan works only when cooling is activated. · When the thermostat is

placed in heat mode, the fan is controlled by the furnace fan control circuitry. 5. Technical Specifications Power supply: 2 AA batteries Maximum load: 1 A

@24 Vac per output Setpoint range (heating): 41 to 82°F (5 to 28°C) Setpoint range (cooling): 59 to 95°F (15 to 35°C) Display range: 23 to 122°F (-5 to 50°C) Storage temperature: -2 to 122°F (-20 to 50°C) Temperature display resolution: 1°F (0.5°C) Accuracy: ± 1°F (0.5°C) Heating/cooling cycle lengths:

10, 12, 15, 20 or 30 minutes (programmable) Compressor short-cycle protection (minimum off time): 5 minutes Data memory: non-volatile Dimensions: 5 in.

x 3 in.

x 1 in. (127 mm x 75 mm x 28 mm) ON The fan is always on. 3.3 Displaying the Temperature The actual temperature is normally displayed. To view the

setpoint, press once on either of the buttons. The setpoint is displayed for 5 seconds along with the icon. Note: Pressing any of the the setpoint. buttons more than once will change 6. Warranty Honeywell warrants this product, excluding battery, to be free from defects in the workmanship or materials, under normal use and service, for a period of one (1) year from the date of purchase by the consumer. If at any time during the warranty period the product is determined to be defective or malfunctions, Honeywell shall repair or replace it (at Honeywell's option).

If the product is defective, (i) return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it, or (ii) call Honeywell Customer Care at 1-800-468-1502. Customer Care will make the determination whether the product should be returned to the following address: Honeywell Return Goods, Dock 4 MN10-3860, 1885 Douglas Dr N, Golden Valley, MN 55422, or whether a replacement product can be sent to you. This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Honeywell that the defect or malfunction was caused by damage which occurred while the product was in the possession of a consumer. Honeywell's sole responsibility shall be to repair or replace the product within the terms stated above.

HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL

DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to you.

THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES ON THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE ONE-YEAR DURATION OF THIS WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.

.

Your user manual

HONEYWELL RTH110B

Powered by TCPDF (www.tcpdf.org)