Hunter Fan 40135 operation manual Operation

Page 21

Operation

1.Set the Set Temperature slider to the desired temperature.

2.The System Switch determines the operating mode of the thermostat. Select Cool, Off, or

Heat.

3.The Fan Switch should normally be located in the Auto position. To run the fan continuously, slide the Fan Switch to the On position.

Note: In Auto , The fan will be turned on along with normal operation of your system. In a normal gas or oil furnace, the fan will be turned on by your furnace after its warm-up delay.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents
Electronic/Mechanical Thermostat Page Table of Contents Electronic/Mechanical Thermostat Important information Two fresh 1.5 Volt AA size alkaline batteries Page Page Locate, but do not disconnect the wires See pg 27 for complete wiring diagram Uninstalling the existing unit, Installing the Thermostat Page Installing the Wall Plate RCG Connecting the Wires HE/HG Switch Attaching the Thermostat Page System Thermometer Switch Operation Indicators and adustment Span Adjust Span Indicators and Adjustments, My heating or cooling will not turn on or off Is there help on the web? Can’t I just call someone? Wire Heat/Cool System Rh W Wiring diagrams, 30 2007 Hunter Fan Company
Top Page Image Contents