Safety Considerations

TCSNAC01, TCSNHP01

Non-- Programmable Thermostat

Installation Instructions

A08147

NOTE: Read the entire instruction manual before starting the installation.

Read and follow manufacturer instructions carefully. Follow all local electrical codes during installation. All wiring must conform to local and national electrical codes. Improper wiring or installation may damage thermostat.

Recognize safety information. This is the safety-alert symbol . When you see this symbol on the equipment and in the instruction manual, be alert to the potential for personal injury.

Understand the signal words DANGER, WARNING, and CAUTION. These words are used with the safety-alert symbol. DANGER identifies the most serious hazards which will result in severe personal injury or death. WARNING signifies a hazard which could result in personal injury or death. CAUTION is used to identify unsafe practices which may result in minor personal injury or product and property damage. NOTE is used to highlight suggestions which will result in enhanced installation, reliability, or operation.

Power

Note that all thermostats are dual powered where batteries can be installed or in the presence of R and C (24vac) are not required. Two AA batteries are furnished with the product.

Models

There are 2 different models. The 5th and 6th letters of the part number indicate the model. These 2 letters also appear on the package and on the circuit board. Be sure to have the proper thermostat for the intended application. Models are:

AC - 1-stage cool, 1-stage heat for AC systems only.

HP - 1-stage cool, 2-stage heat for either HP, or AC with 2-stage heat.

Use each only for its intended purpose. See Table 1.

INSTALLATION

Thermostat Location

Thermostat should be mounted:

SApproximately 5 ft. (1.5m) from floor.

SClose to or in a frequently used room, preferably on an inside partitioning wall.

SOn a section of wall without pipes or duct work.

Thermostat should NOT be mounted:

SClose to a window, on an outside wall, or next to a door leading to the outside.

SExposed to direct light and heat from a lamp, sun, fireplace, or other temperature-radiating object which may cause a false

reading.

SClose to or in direct airflow from supply registers and return-air grilles.

SIn areas with poor air circulation, such as behind a door or in an alcove.

Select Model

AC Model

(1-stage cool, 1-stage heat) is to be used for single stage heating and/or cooling applications only.

HP Model

(1-stage cool, 2-stage heat) can be used with a single-speed heat pump (HP), or an air conditioner (AC) with a 2-stage furnace or fan coil. Software Option 5 selects HP/AC operation. This thermostat comes configured from the factory as a heat pump thermostat. Select AC in software Option 5 for AC operation.