1 TRIM INSTALLATION
Remove PLASTER GUARD (1).
Remove HANDLE SCREW and ADAPTER (7) from rough valve.
Push CAPS (2 & 3) as shown onto CONTROL VALVES (4).
Push ESCUTCHEON (5) onto CAPS (2 & 3) and attach with (60mm) SCREWS (6) to valve.
Push COVER PLATE (7) onto CAPS (2 & 3) and snap into holes in ESCUTCHEON (5) to secure.
4
7
2
5
7
TOP
3 6
1
2 INSTALL HANDLES
Install HANDLE ADAPTER (1) onto VOLUME CONTROL SPLINE (2).
Align CROSS HANDLE (3) and push onto HANDLE ADAPTER (1). Install HANDLE SCREW (4) in CROSS HANDLE (3) and tighten with flat blade screwdriver. Insert index button (5).
Align the two splines in LEVER HANDLE (6) with the knob mount arrow (Figure 1) and push LEVER HANDLE (6) onto KNOB MOUNT (7). Install HANDLE SCREW (8) in LEVER HANDLE (6) and tighten with phillips screwdriver. Insert index button (9).
2
7
1
3
4
O
O
5
O
O
N
N
6
KNOB
MOUNTTWO SPLINES ARROW
Figure 1
7
6
8
9
3 TRANSPOSED SUPPLY PIPING OR BACK TO BACK INSTALLATION
Should the hot and cold water supply pipes have been transposed making adjustment impossible, proceed as follows:
Shut off water supply.
Remove handle and rim. (Reverse steps 1 and 2.
Remove check stops and
Important note: RED CHECK STOP is now on the right of the mixer body and the BLUE CHECK STOP is now on the left.
Turn the water supply back on and perform the temperature adjustment in step 2.
Assemble HANDLES and TRIM.
CHECK STOP
(BLUE TO RED)
CHECK STOP
(RED TO BLUE)
M968419 REV 1 . 1