INSTALLATION
5.Connect one stripped wire end to the black and one to the red terminal. Pay attention to the markings on the wire. Each loudspeaker wire must be connected to the amplifier in the same way.
6.If required, attach the safety cable to the loudspeaker enclosure. See Safety First section for details.
7.Verify that the loudspeakers are
8.Angle the loudspeaker for the best sound possible.
9.Tighten the bracket knobs using only your hands. Use of any power tools may
10.Check that the entire installation is safe and secure.
Loudspeaker Phase
Loudspeaker wire has two conductors. One conductor is attached to the negative
1.Point the loudspeakers at each other, rather than at you.
2.Play some music with the amplifier or radio set to Mono.
3.Stand so you are the same distance from each loudspeaker and listen to the richness of the bass and the loudness of the sound.
4.Turn off the amplifier and reverse the connections on one loudspeaker only.
5.Repeat the listening test with the same setting of the volume control. When the sound has a richer bass and is slightly louder the loudspeakers are working together or
17