Niles Audio OS5.3SI, OS6.3Si Tools and Materials Required, Wiring, Incorporating a Volume Control

INSTALLATION CONSIDERATIONS

TOOLS AND MATERIALS REQUIRED

•Electric drill with 1/4- and 1/2-inch drill bits, and a 1-inch flat drill bit for drilling through studs)

•Three screws or bolts suitable for the mounting surface

•The proper screwdriver for the mounting hardware

•Safety cable (optional)

•Cable ties

•Wire stripper

•Pencil

•Level

•Rubber gloves and protective eyewear

WIRING

The OS loudspeakers connect to your receiver or amplifier using 2-conductor loudspeaker wire (see Figure 3 on the next page). For most applications, we recommend using 16- or 18-gauge wire. For wiring runs longer than 80 feet, we recommend 14-gauge wire. The binding posts on OS loudspeakers accommodate up to 12-gauge wire directly. Larger sizes can be accommodated using spade, banana, or pin connectors.

TECH TIP

Wire size is expressed by its AWG (American Wire Gauge) number – the lower the number, the larger the wire. For example, 12 AWG is physically larger than 14 AWG.

When you run wire inside walls, outdoors or in marine installations, special jacketing or conduit is required for a trouble-free installation and conformation to the local and national building codes. If you are not sure of the correct wire jacket or type of conduit to use, consult a professional audio/ video installer, building contractor, or the local building and inspection department.

INCORPORATING A VOLUME CONTROL

It’s possible to control the volume of the sound at the loudspeaker location. Plan to wire the system so the loudspeaker has its own volume control. Niles makes a wide range of indoor and outdoor volume controls with and without muting capabilities. Consult your local Niles dealer for more information. The volume control is connected in line with the loudspeaker, so you must connect the wire from the amplifier to the volume control and then from the volume control to the loudspeaker (see Figure 4 on the next page).

6