LG Electronics PACKAGED TERMINAL AIR CONDITIONER/HEAT PUMP Electrical Safety, Electrical Data

Page 9

Electrical Safety

Electrical Safety

ElectricalData

ENGLISH

115V~

230V~

265V~

Power cord may include a current interrupter device. A test and reset button is provided on the plug case. The device should be tested on a periodic basis by first pressing the TEST button and then the RESET button. If the TEST button does not trip or if the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician.

NOTICE

The shape may be different according to its model.

Use Wall Receptacle

Power Supply

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Use 15 AMP. time

 

 

 

 

 

 

 

 

 

Standard 208/230V, 3-wire

delay fuse or 15 AMP.

Circuit breaker.

grounding receptacle rated 15A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Use 20 AMP. time

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

delay fuse or 20 AMP.

Standard 208/230V, 3-wire

Circuit breaker.

 

grounding receptacle rated 20A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Use 30 AMP. time

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

delay fuse or 30 AMP.

Standard 208/230V, 3-wire

Circuit breaker.

 

grounding receptacle rated 30A

 

 

 

 

 

 

 

 

 

 

 

NOTICE

DO NOT USE AN EXTENSION CORD on 230, 208, and 230/208 Volt units.

All wiring should be made in accordance with local electrical codes and regulations.

Aluminum house wiring may pose special problems. Consult a qualified electrician.

Never push the test button during operation

Otherwise this plug can damaged.

This device contains chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive harm.

Wash hands after handling.

Do not remove, modify, or immerse this plug. If this device trips, the cause should be corrected before further use.

The conductors inside this cord are surrounded by shields, which monitor leakage current.

These shields are not grounded. Periodically examine the cord for any damage. Do not use this product in the event the shields become exposed. Avoid shock hazard! This unit cannot be serviced. Opening the tamper- resistant, sealed portion of the unit voids all warranties and performance claims. This unit is not intended to be an ON/OFF switch.

Owner’s Manual 9

Image 9
Contents LG Packaged Terminal Table of Contents Installation Safety PrecautionsOperation Hold the plug by the end When gas leaks, open Do not block the inlet or outlet of air flow Service Cleaning and MaintenanceBefore Operation Preparing for OperationFeatures Symbols Used in this ManualIntroduction Sleeve and the Rear GrilleElectrical Data Electrical SafetyPlease Read Carefully Electrical SafetyHow to Install the Unit InstallationRemove the shipping screw from the ventilation door Unit InstallationControl Locations Manual ControlsVentilation Electronic Controls Function Self-DiagnosisAdditional Controls Temperature LimitingRemoving the Front Grille Additional ControlsEnergy Saver REMOTE/LOCAL ControlFront Desk Control Remote Wall ThermostatDisassembly Instructions Maintenance and Service Air Filter CleaningVent Filter Chassis DrainageOptionalCompressor / Fan Motor Cabinet FrontCommon Problems and Solutions TroubleshootingNormal Operation Fan motor noise Overload Room AIR Conditioner Voltage LimitsLG ELECTRONICS, INC