Installation
CabinetInstallation
1.Open the window. Mark a line on center of the window stool(or desired air conditioner location).
Carefully place the cabinet on the window stool and align the center mark on the bottom front with the center line marked in the window stool.
2.Pull the bottom window sash down behind the upper guide until it meets.
NOTICE
Do not pull the window sash down so tightly that the movement of Frame Curtain is restricted.
3.Loosely assemble the sill support using the parts in Fig. 3.
4.Select the position that will place the sill support near the outer most point on sill (See Fig. 4)
NOTICE
Be careful when you install the cabinet (frame guides are broken so easily).
5.Attach the sill support to the cabinet track hole in relation to the selected position using 2 Type A screws in each support(See Fig. 4).
6.The cabinet should be installed with a very slight tilt(about 1/2") downward toward the outside (See Fig. 5).
Adjust the bolt and the nut of sill support for balancing the cabinet.
7.Attach the cabinet to the window stool
by driving the screws (Type B: Length sixteen millimeters and below.) through the front angle into window stool.
8.Pull each Frame curtain fully to each window sash track, and repeat step 2.
Upper Guide |
|
|
| Window stool | |
| Front Angle | Fig. 1 |
Window Sash | Upper guide |
|
Cabinet
Frame Curtain 1
Fig. 2
INDOOR | OUTDOOR | |
| Sill Support 2 | |
Bolt 3 | Nut 4 | Fig. 3 |
Frame Guide 12 | Screw(Type A) 5 |
|
|
| |
|
| 1/2" |
|
| About |
| Cabinet |
|
INDOOR | OUTDOOR | Fig. 4 |
|
| |
Screw(Type B) 6 |
|
|
|
| 1/2" |
|
| About |
| Sill support 2 |
Sash track
Front Angle
Screw(Type B) 6
Sill support 2 | Fig. 5 |
ENGLISH
Owner’s Manual 13